Regency F3100L, SC100L, F1100S ASH Disposal, Safety Guidelines, Safety Precautions

Page 18

OPERATING INSTRUCTIONS

ASH DISPOSAL

During constant use, ashes should be removed every few days. The Ash Drawer option fea- tures a convenient ash dump for easy removal of ash, see "Modular Options" on page 7.

Safety Precautions

Bottom Shield (with Legs) Units:

clothing and furniture away. Warn chil-

To remove the drawer, lift slightly and slide

dren of the burn hazard.

it out, and carry it away.

 

8)

The stove consumes air while operating,

 

provide adequate ventilation with an air

 

duct or open a window while the stove is

 

in use.

1)Do not allow ashes to build up to the loading doors! Only remove ashes when the fire has died down. Even then, expect to find a few hot embers.

2)Please take care to prevent the build-up of ash around the start-up air housing located inside the stove box, under the loading door lip.

3)Never start a fire if the ash plug and ash drawer are not in place. This will cause overfiring which can cause excessive warping of the stove. Evidence of overfir- ing can void the warranty on your stove.

4)The firebricks are brittle and can be dam- aged if the plug is replaced carelessly or pieces that are too large are forced through the hole.

Ash Drawer Operating Guideline

1)Only clean ashes out of the stove when the unit has cooled down. Remove the plug by lifting on the handle using the tool provided. The plug may still be warm, use caution. Push the ashes down the hole into the ash drawer, the large pieces can be left in the firebox and burned during the next fire or removed through the door opening.

2)Always leave 1/2 to 1 inch of ash in the bottom of the firebox. This helps in easier starting and a more uniform burn of your fire. Replace ash plug when ashes have been removed.

3)Pedestal Units:

To remove the drawer, lift slightly and slide it out. When the drawer is completely out, slide the cover plate over the ash drawer and carry away.

4)When emptying the ash drawer, make sure the ashes are cold. Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a non-combustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled. Other waste should not be placed in the ash container.

5)Before putting the ash drawer back into place, make sure the ash plug is back in place.

Pedestal Units: make sure the cover lid is off.

SAFETY GUIDELINES

AND WARNINGS

1)Never use gasoline, gasoline type lantern fuels, kerosene, charcoal lighter fuel, or similar liquids to start or ‘freshen up’ a fire in your heater. Keep all such liquids well away from the heater while it is in use.

2)Keep the door closed during operation and maintain all seals in good condition.

3)Do not burn any quantities of paper, gar- bage, and never burn flammable fluids such as gasoline, naptha or engine oil in your stove.

4)If you have smoke detectors, prevent smoke spillage as this may set off a false alarm.

5)Do not overfire heater. If the chimney con- nector, flue baffle or the stove top begin to glow, you are overfiring. Stop adding fuel and close the draft control. Overfiring can cause extensive damage to your stove including warpage and premature steel corrosion. Overfiring will void your war- ranty.

6)Do not permit creosote or soot build-up in the chimney system. Check and clean chim- ney at regular intervals. Failure to do so can result in a serious chimney fire.

7)Your Regency stove can be very hot. You may be seriously burned if you touch the stove while it is operating, keep children,

9)Do not connect this unit to a chimney flue serving another appliance.

10)Do not use grates or andirons or other methods for supporting fuel. Burn directly on the bricks.

11)Open the draft control fully for 10 to 15 seconds prior to slowly opening the door when refuelling the fire.

12)Do not connect your unit to any air distribu- tion duct.

13)Your woodstove should burn dry, stand- ard firewood only. The use of cut lumber, plywood, “mill ends”, etc. is discouraged as this fuel can easily overheat your woodstove. Evidence of excessive over- heating will void your warranty. As well, a large portion of sawmill waste is chem- ically treated lumber, which is illegal to burn in many areas. Salt drift wood and chem- ically treated fire logs also must not be burned in your woodstoves.

14)Do not store any fuel closer than 2 feet from your unit. Do not place wood, paper, fur- niture, drapes or other combustibles near the appliance.

15)WARNING: Do not operate without either the Ash Plug properly seated or the Ash Dump Plates screwed in place, excessive temperatures will result.

16)Do not operate with broken glazing.

18

Regency Freestanding Woodstove

Image 18
Contents Freestanding Woodstoves Regencyfireplaceproduct Table of Contents 2002 Safety Label2003 20042001 1022003 Safety Label Modular Installation Options InstallationResidential Installation Room AIRResidential Installation C Vent Single Wall Minimum Clearance to Combustible MaterialsMinimum Alcove Clearance to Combustible Materials Floor ProtectionRear Heat Deflector Assembly For F1100 & F3100 Stove Assembly Prior to InstallationAirmate Assembly for F1100 & F3100 S3100L Side Shield AdjustmentStep by Step Chimney Connector Installation Leg and Bottom Shield AssemblyMobile Home Installation Recommended Heights for Woodstove FlueCanadian Installations Listed Components For Mobile Home InstallationInstallation PRO-JETBrick Flue Baffle & Secondary AIR Tube Installation Large Stoves F3100L and S3100LSmall Stoves F1100S Optional Accessories Brick Installation Door HandleGlass Installation Pedestal Ash Drawer KitBlower/Fan Wiring Diagram Draft Control Operating InstructionsOperating Instructions First FireASH Disposal Safety GuidelinesSafety Precautions Ash Drawer Operating GuidelineMaintenance Parts List F1100 & F3100 Stove Main AssemblyDescription S3100 Step Stove Main Assembly PEDESTAL, Bottom Shield & LEG Options Firebrick Regency Freestanding Woodstove Regency Freestanding Woodstove Regency Freestanding Woodstove Warranty Warranty LifetimeInstaller Please complete the following information
Related manuals
Manual 28 pages 17.51 Kb

SC100L, F1100S, F3100L specifications

The Regency S3100L, F3100L, and F1100S represent a trifecta of innovative solutions designed to elevate both residential and commercial heating experiences. These models are crafted with advanced technologies to ensure efficient operation and enhanced user comfort, making them ideal choices for various heating needs.

The Regency S3100L is a powerful wood-burning stove that stands out for its impressive heat output and sustainable design. With a maximum output of up to 76,000 BTUs, it effectively heats spaces up to 2,600 square feet. A hallmark feature of the S3100L is its secondary combustion technology, which significantly reduces emissions while maximizing heat efficiency. The stove’s clean glass window provides a captivating view of the flames, enhanced by the air-wash system that keeps the glass clear. Its durable construction and traditional aesthetic make it a timeless addition to any home.

Transitioning to the F3100L, this model offers versatility with its remarkable dual-fuel capability, supporting both natural gas and propane. Equipped with advanced electronic ignition and a powerful fan assist, the F3100L efficiently distributes warmth throughout larger areas. Additionally, its ceramic glass viewing area emphasizes the elegance of the flames while allowing for optimal heat retention. The stove features an adjustable thermostat that allows users to maintain the perfect temperature effortlessly, catering to personal preferences and ensuring comfort throughout varying seasons.

Lastly, the F1100S is designed for smaller spaces without compromising on performance. This compact yet robust wood-burning stove is capable of heating up to 1,500 square feet, making it ideal for cabins, smaller homes, or supplemental heat in larger spaces. The F1100S features a simple ash removal system, promoting ease of maintenance, while its sleek design and reduced footprint make it suitable for more confined environments. Like its counterparts, the F1100S includes secondary combustion technology that enhances efficiency and reduces emissions, reinforcing Regency’s commitment to sustainable heating solutions.

Collectively, the Regency S3100L, F3100L, and F1100S embody a commitment to quality, efficiency, and user-friendly features. Each model embraces modern technologies while delivering the timeless warmth and ambiance associated with traditional heating methods. Whether your needs are for expansive spaces or cozy retreats, these stoves epitomize the perfect blend of functionality and aesthetic appeal, making them valuable assets for any heating arrangement.