Regency S3100L, F3100L, F1100S Brick Installation, Door Handle, Screen Door, Glass Installation

INSTALLATION

BRICK INSTALLATION

Firebrick is included to extend the life of your stove and radiate heat more evenly. Check to see that all fi rebricks are in their correct posi- tions and have not become misaligned during shipping.

The "AD" brick in the drawings above is the brick covering the Ash Dump hole that is used when the Ash Drawer Kit is installed (refer to the Listed Components for Mobile Home Instal- lation section).

Handle at 10 o'clock position.

NOTE: The handle must be positioned at 10 o'clock when closed to avoid the handle from getting hot and to ensure the screen stays in place.

DOOR HANDLE

Attach spring handle by rotating counter clockwise onto rod. Ensure that the rod fi ts into the entire length of the spring handle. See Diagram below.

Pedestal Ash Drawer Kit (850-100)

1) Remove the bricks from the fl oor of the

firebox.

2)If using ashdrawer, discard cover plate.

3)Remove the ash dump cover plates (one inside the fi rebox and one on the underside of the fi rebox) by removing the two nuts and bolts holding the 2 plates together from inside the fi rebox.

4)Push the ash plug into the hole inside the

firebox and replace all the bricks except for the brick over the ash plug. See brick diagrams.

5)Place the ash drawer lid inside the pedestal, and the ash plug tool beside the lid, then slide the ash drawer inside so it sits on top of the lid.

Freestanding - Small F1100

Freestanding - Large F3100

SCREEN DOOR

Hook screen to the inside on the right side of the fi rebox door opening. Lock in place by turning handle.

GLASS INSTALLATION

Your Regency stove is supplied with 5 mm Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorized Regency dealer only.

Remove the door from the stove and remove the glass retainer. Position the glass in the door, make sure that the glass gasketing will properly seal your unit, and replace the retainer, it should rest on the gasket not the glass.Tighten securely, but do not wrench down on the glass as this may cause the glass to break.

Refer to the Ash Drawer Operating section.

Bottom Shield Ash Drawer Kit

(850-101 )

1) Remove the bricks from the fl oor of the

firebox.

2)Remove and discard the cover plate by removing the two screws on the front of the Bottom Shield.

3)Remove the ash dump cover plates (one inside the fi rebox and one on the underside of the fi rebox) by removing the two nuts and bolts holding the 2 plates together from inside the fi rebox.

4)Push the ash plug into the hole inside the

firebox and replace all the bricks except for the brick over the ash plug. See brick diagrams.

5)Place the ash plug tool beside the lid, then slide the ash drawer inside.

OPTIONAL

ACCESSORIES

Hooks Handle Lock

The pieces listed below can be purchased and

Back Side of Screen Shown installed during the initial installation or added Refer to the Ash Drawer Operating section. on later.

Regency Freestanding Woodstove 17