Regency Wraps I2400M installation manual Maintenance

Page 15

MAINTENANCE

MAINTENANCE OF

GOLD-PLATED DOORS

The gold electroplated fi nish on the doors requires little maintenance, and need only be cleanedwithadampcloth.DONOTuseabrasive materials or chemical cleaners, as they may harm the fi nish and void the warranty.

GLASS CLEANING

Only clean your glass window when it is cool. Your local retailer can supply you with special glass cleaner if plain water and a soft cloth does not remove all deposits.

DOOR GASKET

If the door gasket requires replacement, 7/8" diameter material must be used. A proper high temperature gasket adhesive is required. A gasket repair kit, Part # 846-570 is available from your local Regency dealer.

GLASS REPLACEMENT

Your Regency Insert is supplied with 5 mm. Neoceram ceramic glass (Part #846-304) that will withstand the highest heat that your unit will produce. In the event that you break your glass by impact - purchase your replacement from an authorized Regency dealer only, and follow our step-by-step instructions.

DOOR LATCH

ADJUSTMENT

The door latch may require adjustment as the door gasket material compresses after a few

res. Removal of the spacer washer, shown in the diagram below, will allow the latch to be moved closer to the door frame, causing a tighter seal. Remove and replace the nuts, washer as shown.

GLASS REMOVAL

Allowthestovetocoolbeforeremovingorreplac- ing glass. Remove the door from the insert and remove the glass retainer. Use caution when removing broken glass to prevent injury.

When placing the replacement glass in the door, make sure that the glass gasketing will properly seal your unit. Replace the retainer and tighten securely, but do not wrench down on the glass as this may cause breakage. Do not substitute materials. If your glass door does break, do not continue to use your unit until it has been replaced.

Avoid impact on glass doors such as striking or slamming shut.

Regency I2400M

15

Image 15
Contents Wood Regency Fireplace Product Table of Contents Safety Label for I2400M Safety LabelUnit Dimensions Wood Insert Specifications InstallationBefore Installing Your Insert Chimney SpecificationsOptional Flue Connector KIT Installing Your InsertMax. mantle depth is 10 254mm Masonry and Factory Built Fireplace ClearancesSTEP-BY-STEP Installation Into a Factory Built Fireplace Flue Connector BracketSTEP-BY-STEP Installation Faceplate and Trim STEP-BY-STEP Installation FAN/BLOWER Draft Control Firebrick AssemblyFlue Baffle Secondary AIR Tube Installation Floor ProtectionSome Safety Guidelines Operating InstructionsFirst Fire ASH Disposal FAN OperationWood Storage Maintenance Main Assembly & Options I2400M Parts ListFaceplates I2400M Brick Panels I2400M Warranty Lifetime WarrantyInstaller Please complete the following information