FIREPLACE INSERT |
| |
SURROUND PANELS |
| |
To complete the picture after the insert is installed in your fireplace, a set of panels are attached to the insert to | 24 | |
accommodate the size variance between the custom insert face and the size of your existing fireplace opening. | ||
| ||
Lopi offers four different ways to finish off your fireplace insert. |
| |
RECTANGULAR FINISH PANELS |
|
Designed to fit over the existing fireplace opening. These panels can also be cut down to fit within the opening of the fireplace.
DVS Panel Coverage
4” x 6” 37 1/8” W x 25” H
8” x 10” 40 3/8” W x 28 7/8” H 10” x 13” 44 3/8” W x 31 7/8” H
DVL Panels Coverage
4” x 6” 40” W x 29” H
8” x 10” 44 3/16” W x 33 3/8” H 10” x 13” 48 3/16” W x 36 3/8” H
Shown with panels extending over the | Shown with panels cut down to fit |
fireplace opening | the inside of the fireplace opening |
ARCHED FINISH PANELS
If you have an arch opening or arched fireplace mantel Lopi offers Ached Panels to match the arched design of your existing fireplace.
Arch Panels are available for both the DVS and DVL in 8” x 10” and
10” x 13” panel sizes.
LOWER ZC PANEL
Designed to be used with Rectangular Finish Panels. This panel offers a finished look to fireplace that are elevated above the floor.
This panel is trimmable and will cover up to 7” below the insert. The Lower ZC Panel also include extended trim to replace the side trim that comes with the standard panel sets
CLEARANCES TO COMBUSTIBLES |
|
|
| |
|
|
|
| A |
A = Floor to Mantel 35”* | A = Floor to Mantel* 35 1/2”* |
| A | B |
B = Floor to Top Facing 35”* | B = Floor to Top Facing 35 1/2”* |
|
| |
|
|
| ||
C = Insert to Sidewall 4 1/2” | C = Insert to Sidewall 4” |
|
|
|
D = Insert to Side Facing 4 1/2” | D = Insert to Side Facing 4” | C |
| D |
E = Extension onto Hearth 1 1/4” | E = Extension onto Hearth 1 1/4” |
|
|
|
F = Hearth Not Required | F = Hearth Not Required | E |
| F |
* Measured from the base of the insert. | * Measured from the base of the insert. |
| ||
|
|
| ||
The |
|
|
| |