Lopi Direct Vent Freestanding Stove owner manual Safety Label, Sturbridge

Page 30

3 0

Safety Label

The safety (listing) label is on the back of the stove. A copy of the safety label is shown below.

Sturbridge

Vented Gas

Fireplace Heater

Report No. 028-S-50-5

Certified for USA

Tested to: ANSI Z21.88b-2001 “Vented Gas Fireplace Heater” and UL 307b-1995 “Gas Burning Heating Appliances for Manufactured Homes”.

VENTED GAS FIREPLACE HEATER – NOT FOR USE WITH SOLID FUEL

This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1.

This vented gas fireplace heater is equipped at the factory for use with natural gas. If conversion to propane (LP) is desired, the optional factory conversion kit must be used.

This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an after- market, permanently located, manufactured (mobile) home where not prohibited by local codes. See owner’s manual for details.This appliance is not convertible for use with other gases, unless a certified kit is used.

This vented gas fireplace heater is not for use with air filters.

Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.

WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional infor- mation consult a qualified installer, service agency or the gas supplier.

WARNING: Operation of this appliance when not connected to a properly installed and maintained venting sys- tem or tampering with the blocked vent shutoff system can result in carbon monoxide (CO) poisoning and possi-

ble death.

. See owner

CAUTION: Do not operate this appliance with glass removed, cracked or broken. Replacement of the panel(s) should be done by a licensed or qualified service person.

CAUTION: Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids hav- ing flammable vapors away.

This appliance must be properly connected to a venting system in accordance with the manufacturer’s installa-

tion instructions. Use only approved coaxial direct vent system to vent this appliance to the exterior ’s manual for approved brands of venting.

Minimum Clearances to Combustibles

Stove Top to Sidewall

3.5”

Alcove Min. Height

36”

 

Stove Top to Backwall

4.75”

Alcove Max. Depth

48”

 

Stove Top to Cornerwall

1”

Alcove Min. W idth

27.75”

 

Glass Front of Unit

36”

 

 

 

 

 

 

 

 

 

 

L.P.

N.G.

 

L.P.

N.G.

Input Rate on “HI” (BTU/Hr)*

18,000

18,000

Minimum Inlet Pressure (inches W.C.)

11”

5.5”

Input Rate on “LO” (BTU/Hr)*

14,600

14,100

Manifold Pressure on “HI” (inches W .C.)

10”

3.5”

This appliance is equipped only for altitudes 0-2000 ft. (0-610 m).

Electrical Rating: 115v, 1.5 Amps, 60 Hz

Manufacture

 

2002

 

 

 

Jan.

 

 

Apr.

 

 

Jul.

 

 

Oct.

 

Date:

 

2003

 

 

 

Feb.

 

 

May

 

 

Aug.

 

 

Nov.

10850 117th Pl. N.E. Kirkland, WA 98033

 

 

 

 

 

 

 

 

 

2004

 

 

 

Mar.

 

 

 

Jun.

 

 

 

Sep.

 

 

 

Dec.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

IGN 0466

Travis Industries

1 0 0 - 0 1 1 4 2

4 0 5 0 1 1 4

Image 30
Contents Featuring the Burner 2Introduction Introduction Important InformationTravis Industries 0 0 1 1 4 5 0 1 1 Table of Contents Safety Precautions If YOU Smell GASThis Manual Dimensions & Weight 6SpecificationsHeating Specifications Electrical Specifications for optional blowerInstallation Warnings Installation OverviewPacking List Additional Items Required Installation Hints Stove ClearancesMobile Home Requirements Heater Placement Requirements Floor Protection RequirementsGas Line Installation Gas Inlet PressureVent Requirements Manuafacturer R i e sApproved Vent Configurations Restrictor PositionDiffuser Plate Removal Measuring Vent Lengths Approved Venting Configurations for Horizontal Terminations Approved Venting Configurations with a Vertical Termination Propane LPVent Termination Requirements see illustration below Finalizing the Installation Correct Glass Removal Re-Attaching the Glass FrameGlass Frame Removal and Installation Log Installation Installing the Rock Wool2Operation Before You Begin Location of Controls See explanation belowOperation Starting The Pilot FlameStarting the Stove for the First Time Adjusting the Flame Height4Operation Turning the Stove On and OffNormal Operating Sounds Adjusting the Blower Speed optionalOperation2 Normal Operating OdorsPainted Surfaces Yearly Service ProcedureMaintaining Your Stoves Appearance GlassMaintenance TroubleshootingHow this Stove Works What Turns the Main Burners On and OffWhat Prevents Gas Buildup Wiring Diagram Replacement Parts ListSafety Label SturbridgeYears 3 Through 5 Coverage Parts & Labor Limited 7 Year WarrantyYears 1 & 2 Coverage Parts & Labor Years 6 & 7 Coverage Parts onlyOptional Accessories Burner Replacement LP Conversion InstructionsApply thread sealant to the new orifice and install Install the log set see Replace the glass see Blower Attach the blower following the directions belowDo not plug Heater Until Installation is Complete Fireback Stone or Cast Inserts 0Installation Addenda Addendum #1 Class a Chimney Conversion KitInstallation Addenda Addendum #2 Masonry ChimneyConversions 2Index

Direct Vent Freestanding Stove specifications

The Lopi Direct Vent Freestanding Stove stands out as a leading choice for homeowners seeking efficient and elegant heating solutions. Known for its innovative design and advanced technology, the stove combines aesthetic appeal with exceptional performance, making it an ideal addition to any living space.

One of the main features of the Lopi Direct Vent Freestanding Stove is its direct venting system. This technology allows the stove to draw air from outside for combustion and eject exhaust gases outdoors, ensuring optimal indoor air quality. This not only enhances efficiency but also eliminates the need for a traditional chimney, making installation simpler and versatile.

The stove's design is both modern and traditional, featuring clean lines and a variety of finishes to complement any décor. Available in different sizes, the Lopi stove can fit comfortably in various spaces while providing powerful heating. Its large viewing window invites warmth and ambiance, allowing users to enjoy the mesmerizing flames without compromising heat output.

Boasting impressive heating capabilities, the Lopi Direct Vent Freestanding Stove has a high BTU output, effectively warming spaces even in the coldest of climates. The unit is equipped with a robust heat exchanger that maximizes heat retention while minimizing fuel consumption. Furthermore, the stove can operate using either natural gas or propane, offering flexibility based on availability and preference.

In terms of efficiency, many models in this line come with an EPA certification, demonstrating a commitment to environmentally friendly practices. With features such as adjustable flame settings and a thermostatic remote control, users can easily customize their heating experience, ensuring comfort at all times.

Safety is also a priority with the Lopi Direct Vent Freestanding Stove. It includes built-in safety features such as a protective screen and cool-to-the-touch body, making it suitable for homes with children or pets. The durable construction ensures longevity, with high-quality materials designed to withstand the test of time.

In summary, the Lopi Direct Vent Freestanding Stove combines sleek aesthetics with cutting-edge technology to deliver an unparalleled heating solution. With its array of features, efficiency, and safety measures, it not only enhances home comfort but also adds a touch of elegance to any living environment. Whether enjoying the warmth on a chilly evening or creating a cozy atmosphere, the Lopi stove stands out as a top choice for modern homeowners.