Regency Screen Door, Draft Control, Small Insert I1100S, Hearth Heater H2100M Steel Baffle

Page 12

INSTALLATION

Small Insert I1100S

1)If the two air tubes are installed continue on toStep2),ifnot,followtheinstructionsbelow. Install the air tube into the holes in the side channels. The notch goes on the right hand side with the air holes facing toward the door. Slide the tube into the left hand side, as far as possible and then bring it back into the hole on the right hand side until it locks into position. If the tube will not slide in easily simply use a pair of vise grips or pliers and tap it into place with a hammer. A tighter fi t will ensure the tube will not move when the unit is burning. There are only two air tubes in the small units (refer to the diagram in the Large Insert I3100L section).

2)Slide the left baffl e brick over the front air tube and then slide it back over the rear air tube.

Side View

Hearth Heater (H2100M)

Steel Baffle

Place the insulation batt on top of the baffl e. Make sure that this batt is laying fl at and does not obstruct the smoke from getting up the fl ue opening. This insulating batt may be wrapped in paper for handling purposes and does not require removal. Batt hold down weights are supplied with the unit and are to be placed on the insulation to either side of the flame spreader as shown in the diagram and at the rear, directly in front of the fl ue opening.

Lift the front end of the baffl e up and over

the rear of the

air tube. On

Hearth Heater

(H2100M) re-

move

center

tube

by slid-

ing it sideways

first and then down.

Lift the rear of the baffl e, pivoting it on the air tube, until it clears the rear air channel.

Pull Open

Push Closed

As well as a primary and glass wash air system, the unit has a full secondary draft system that allows air to the induction ports at the top of the fi rebox, just below the fl ue baffl e.

WARNING: To build a fire in ignorance or to disregard the information contained in this section can cause serious permanent dam- age to the unit and void your warranty.

SCREEN DOOR

Hook screen to the inside on the right side of the fi rebox door opening. Lock in place by turning handle.

3)Tilt the left baffl e brick up on top of the side channel and it will leave enough room to position the right baffl e brick in the same manner as Step 1) above. Then reposition the left baffl e brick fl at on the air tube.

Front View

4)Important: push both baffle bricks so they are tight against the side walls.

 

 

 

 

 

 

 

 

Hooks

Handle Lock

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Back Side of Screen Shown

 

 

 

 

 

 

 

 

NOTE: The handle must be positioned at 10

 

 

 

 

 

 

 

 

Slide the rear of the baffl e on top of the rear

o'clock when closed to avoid the handle from

air channel in front of the locating tabs. Make

getting hot and to ensure the screen stays in

place.

 

sure that the insulation is lying fl at and does

 

not obstruct the smoke from getting up the fl ue opening. Place hold down weights on top of the insulation - one on each side.

Handle at 10 o'clock position.

Front View

Note: When getting the chimney cleaned, remove the baffle bricks for access to the flue, then replace them when cleaning is completed.

DRAFT CONTROL

Before establishing your fi rst fi re, it is important that your fully understand the operation of you draft control. The draft rod is on the left side of the Inserts and it controls the intensity of the fi re by increasing or decreasing the amount of air allowed into the fi rebox. To increase your draft - pull open, and to decrease - push closed.

WARNING

Fireplace Stoves equipped with doors should be operated only with doors fully closed. If doors are left partly open, gas and flame may be drawn out of the fireplace stove opening, creat- ing risks from both fire and smoke.

When operated with doors open the manufacturer supplied screen must be used.

12

Regency Wood Insert & Hearth Heater

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Wood 908-332b 11/15/07Regency Fireplace Product Table of Contents Safety Label Here for your reviewSafety Label for H2100M 103Installation Before Installing Your InsertChimney Specifications Fireplace SpecificationsOptional Flue Connector KIT Masonry and Factory Built Fireplace ClearancesAdjacent Mantle Top Side Minimum Unit Hearth SideFlue Connector Bracket Installation Into a Factory Built FireplacePositive Flue Direct Flue Connection With Cleanout No Cleanout Full Flue Liner RequiredFaceplate and Trim H2100M and I3100L InsertI1100S Small Insert All unitsFAN / Blower Firebrick Assembly Brick Flue Baffle & Secondary AIR Tube InstallationFloor Protection Door HandleScreen Door Draft ControlSmall Insert I1100S Hearth Heater H2100M Steel BaffleSome Safety Guidelines Operating InstructionsFirst Fire FAN Operation ALL UnitsMaintenance Parts List I1100 & I3100 Main AssemblyDescription Faceplate I3100L Faceplate I1100S H2100 Main Assembly DescriptionFaceplate H2100M 846-531I1100, I3100 & H2100 Firebrick Warranty Warranty LifetimeInstaller Please complete the following information
Related manuals
Manual 20 pages 57.96 Kb

I1100S specifications

The Regency I1100S is a remarkable piece of technology that epitomizes modern design and functionality. Tailored for individuals who seek both performance and aesthetics in their audio devices, the I1100S delivers an impressive sound experience while embodying an elegant and contemporary style.

One of the standout features of the Regency I1100S is its high-fidelity audio output. Sporting advanced audio processing technologies, this device ensures that listeners enjoy crisp highs and deep lows, capturing the full spectrum of sound with clarity and precision. Whether it’s music, podcasts, or audiobooks, the I1100S offers an immersive listening experience, making it a perfect companion for both casual listeners and audiophiles alike.

Another key characteristic of the I1100S is its wireless capabilities. Equipped with Bluetooth technology, the device allows users to stream audio directly from their smartphones, tablets, or computers without the hassle of cords. This wireless freedom enhances convenience, allowing users to move about freely while still enjoying their favorite sounds.

The I1100S also prioritizes usability with its user-friendly interface. Intuitive controls and a clear display make navigating through tracks and settings a simple task. The one-touch operation allows for quick responses, ensuring that users can switch songs or adjust volumes seamlessly, without distraction from their listening experience.

Durability and design are important aspects of the I1100S as well. Crafted with high-quality materials, it features a robust build that can withstand everyday use. Its sleek design complements any environment, whether placed in a living room, office, or on a bookshelf. Available in a variety of finishes, users can select a look that best suits their personal style.

In terms of connectivity, the Regency I1100S offers multiple input options, including USB and auxiliary ports, providing versatility for various playback devices. This means that whether users want to connect a traditional audio device or use modern streaming methods, they have the flexibility to do so.

Lastly, the I1100S is designed with energy efficiency in mind. It operates on low power consumption without compromising sound quality, making it an environmentally friendly choice in audio technology.

In summary, the Regency I1100S is more than just an audio device; it's a sophisticated blend of cutting-edge technology, user-centric design, and aesthetic appeal. With its outstanding audio performance, wireless capabilities, and durable construction, the I1100S stands out in the competitive landscape of modern audio solutions, catering to the needs of diverse users seeking both quality and style.
Top Page Image Contents