Logitek Standard Elec. Cable Manufacturing C/A210 operation manual Contents

Page 2

Contents
Testing Information	3
General Safety Precautions	3
Drafting	4
Negative Pressure Warning	4
Creosote	4
Ash Disposal	5
Fuel	5
Break-InPeriod	5
Paint Curing	5
Brick Installation	6
Required Clearances	7
Chimney Requirements	8
Installation Procedures-MasonryChimney	8
Installation Procedure - Factory-Built Zero Clearance Fireplaces	9
Fireplace Pre-InstallationPreparation	9
Insert Pre-InstallationPreparation	9
Chimney Liner Installation	10
Installing the Insert	10
Post Installation Checks	10
Operating Hints	11
Starting and Maintaining a Fire	12
Clean Glass	13
Operating Techniques and Hints	13
Getting the Most Out of Your Stove	13
Maximizing Your Stove’s Overall Efficiency	14
Achieving Clean, Long Burns	14
Maintenance	15
Troubleshooting	16
Do’s and Don’ts	17

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Image 2

Contents EPA Certified Wood-Burning Fireplace Inserts Contents Testing Information General Safety PrecautionsNegative Pressure Warning Negative pressures described aboveDrafting CreosoteBreak-In Period Ash DisposalFuel Paint Curing= 4-1/2 x 5-1/2 C = 4-1/2 x 6-1/4 D = 3 x 6-1/4 Next, install the front baffle bricks #33-38 underBrick Installation Side View of the FireboxM9 229mm Required ClearancesSide view of optional mantel deflector shown Top ViewStove and it’s parts Installation Procedures- Masonry ChimneyBooklet Chimney RequirementsSee Required Clearances on Original conditionInstall the brick and baffle as per Post Installation ChecksBurn only dry, well-seasoned wood for maxi Burn wet wood or anything other than cleanAt all times except when loading wood Dry wood productsStarting and Maintaining a Fire Getting the Most Out of Your Stove Clean GlassOperating Techniques and Hints Achieving Clean, Long Burns Maximizing Your Stove’s Overall EfficiencyMaintenance Ventilate See Break-in Procedures on Add fuel at lower firebox temperaturesProcedures on Check draft See Poor Draft section aboveDo’s and Don’ts 775,212M REV. a 04/2007