Interior Finish

If products cannot be ﬁnished immediately, cover with clear plastic to protect from dirt, damage and moisture. Remove any construction residue before ﬁnishing. Sand all wood surfaces lightly with 180 grit or ﬁner sandpaper. DO NOT use steel wool. BE CAREFUL NOT TO SCRATCH THE GLASS. Remove sanding dust.

Pella products must be ﬁnished per the below instructions; failure to follow these instructions voids the Limited Warranty.

Ř2QSDWLRGRRUVLWLVRSWLRQDOWRSDLQWVWDLQRUŵQLVKWKHYHUWLFDODQGKRUL]RQWDOSDQHOHGJHV

Note: To maintain proper product performance do not paint, ﬁnish or remove the weather-stripping, mohair dust pads, gaskets or vinyl parts. Air and water leakage will result if these parts are removed. After ﬁnishing, allow venting windows and doors to dry completely before closing them.

Pella Corporation is not responsible for interior paint and stain ﬁnish imperfections for any product that is not factory-applied by Pella Corporation. Use of inappropriate ﬁnishes, solvents, brickwash, or cleaning chemicals will cause adverse reactions with the window and door materials and voids the Limited Warranty.

For additional information on ﬁnishing see Pella Owner’s Manual or go to www.pella.com.

CARE AND MAINTENANCE

Care and maintenance information is available by contacting your local Pella retailer. This information is also available at www.pella.com.

IMPORTANT NOTICE

Because all construction must anticipate some water inﬁltration, it is important that the wall system be designed and constructed to properly manage moisture. Pella Corporation is not responsible for claims or damages caused by anticipated and unanticipated water inﬁltration; deﬁciencies in building design, construction and maintenance; failure to install Pella® products in accordance with Pella installation instructions; or the use of Pella products in wall systems which do not allow for proper management of moisture within the wall systems. The determination of the suitability of all building components, including the use of Pella products, as well as the design and installation of ﬂashing and sealing systems are the responsibility of the Buyer or User, the architect, contractor, installer, or other construction professional and are not the responsibility of Pella.

Pella products should not be used in barrier wall systems which do not allow for proper management of moisture within the wall systems, such as barrier Exterior Insulation and Finish Systems, (EIFS) (also known as synthetic stucco) or other non-water managed systems. Except in the states of California, New Mexico, Arizona, Nevada, Utah, and Colorado, Pella makes no warranty of any kind and assumes no responsibility for Pella windows and doors installed in barrier wall systems. In the states listed above, the installation of Pella products in barrier wall or similar systems must be in accordance with Pella installation instructions.

Product modiﬁcations that not approved by Pella Corporation will void the Limited Warranty.