MTD Series 020 warranty Attaching the Handle, Into the handle. See Figure

ATTACHING THE HANDLE

1.Remove the hairpin clips from the handle brackets and remove the carriage screws and wing nuts from the lower handle.

a.Place the bottom holes in lower handle (notch

pointing down) over the pins on the handle brackets and secure with hairpin clips. See Figure 3-2.

b. Insert carriage screws through upper hole in lower handle from the inside and secure with wing nuts. See Figure 3-2.

2. a. Unfold the upper handle until it aligns with lower handle. Make sure the rope guide is on the right side of upper handle. See Figure 3-3.

IMPORTANT: Make sure the cables are routed outside		notch
the lower handle. Also, do not crimp the cables while
lifting up the handles.		Figure 3-2
	b. Secure the two handles by tightening the star
	knobs (carriage bolts must be seated properly
	into the handle). See Figure 3-3.	A
3.	Loosen the wing nut that secures the rope guide to

the right side of upper handle.

a. Pull the starter rope out of the engine slowly. See Figure 3-4.

b. Slip the starter rope into the rope guide. c. Tighten the wing nut. See Figure 3-4.

B

Figure 3-3

C

A

B

Figure 3-4

3

Setting

Up Your

Chipper

Shredder

Vacuum

IMPORTANT

Make sure the cables are routed outside the lower handle. Also, do not crimp the cables while lifting up the handles.