Lifebreath Official Manual and Specifications for 95 MAX

DIMENSIONS 95MAX inches (mm)

		18.5"
		(470 mm)
24.5"	(622 mm)	Removably
		Heat Recovery
		Core
		Drain Pan
		Drain spout
		FRONT

	Hanging
knockout for	straps (4)
		Threaded
side mounting of		inserts (4)
EXHAUST return port
		at corners
6" round collar
converted to oval	18.5"
			(470 mm)
		SUPPLY
		Fresh air
		from outside
		5" round collar
		SUPPLY
minimum		Fresh air
		to building
18 inches (459 mm)
		6" round
required for
		(conv. to oval)
service access
		collar

16"

(406 mm)

SIDETOP

EXHAUST

Stale Air

to outside

5" round collar

EXHAUST Return air from building

Choice of port location Knockouts on top and side of unit (use 1 only) 6" round (conv. to oval) collar supplied

95 MAX Port Specifications

The 95 Max Heat Recovery Ventilator (HRV) has been designed to allow the installer to choose between two possible positions on the cabinet for the INDOOR EXHAUST (return from building) port. Illustrations in this manual show standard (side mounted) port location . The same specifications apply to both 95 Max setups, regardless of which port position is selected.

In order to make the 95 Max as space efficient as possible, the INDOOR supply and return ports are converted from round to oval shape. Overall size of the port remains the same. Simply bend a standard duct fitting to the correct shape, and attach to the oval port using the same method as for a round port.

(6 inch)

diameter

Same Circumference

HEAT
RECOVERY	VENTILATORS	(HRVs)	HEAT	RECOVERY	VENTILATORS (HRVs)

SIDE MOUNTED PORT	TOP MOUNTED PORT
standard location	alternate location

Variable Port Location

Variable Port Location / Installation (Model 95 Max only)

The exhaust return port collar is not factory installed. Installer may choose either side mounted or alternate top mounted port by simply removing one of the two knock-out plates and attaching a port collar (supplied). To remove knock-out plate, insert a utility knife into the knock-out slits and trace them completely to puncture protective film underneath. Then, cut the solid tabs between the slits, using tin snips or side cutters, and remove the knock-out plate. If any protective film still blocks the opening, remove it now.

Round port bent to oval

95 MAX Air Flow

Stale air enters the FRONT RIGHT side port. The air will pass down the front half of the core, then up the back half of the core and out the RIGHT REAR port.

Fresh outdoor air will enter the LEFT REAR port and pass down the back half of the core. It will then pass up the front half of the core, and out the LEFT FRONT port. This unique configuration allows the air to actually travel through the core twice, making the 95 MAX almost as efficient as a double core unit.

17