Koblenz/Thorne Electric U-800, U-900 Vacuum Assembly, Attaching the Handle Replacing the Dust BAG

Page 5

VACUUM ASSEMBLY

ATTACHING THE HANDLE

REPLACING THE DUST BAG:

1.Remove the handle screw.

2.Insert handle into top of dust cover with handle switch facing forward.

3.Align small hole on handle with screw hole in dust cover.

Insert screw and tighten securely. (All models)

4.Turn cord storage hook to upright position and wind cord between upper and lower hooks to store.

5.To quick-release cord: simply rotate hook downward and cord will drop for immediate use.

*Remember: Always have a dust bag installed when operating your Vacuum Cleaner. Replace with a genuine dust bag when full.

1.Push down on knob at top of dust cover to open compartment.

2.Pull cardboard bag collar off holder. Remove and discard used dust bag.

3.Slide clean replacement bag collar onto holder.

4.Close dust cover by reinserting tab on lower edge into groove on housing and snap shut.

CHECKING THE SECONDARY FILTER:

*Important: The secondary filter protects the motor from dust and dirt. 1.Check for accumulated dust and dirt when replacing dust bag.

2.If replacement is needed, release the right tab on underside of bag supporter. Lift and rotate bag supporter to remove.

(Bag supporter for Model U-900)

3.Remove secondary filter from bottom of dust compartment.

4.Replace secondary filter with new filter.

5.Reinstall bag supporter.

-5 -

Image 5

Contents Operating Instructions Manual DE Usuario Read ALL Instructions Before Using this Appliance Important Safety InstructionsModel U-800 Commercial Commercial Model U-800 & U-900Parts Identification Model U-900 Commercial HOW to Install Cleaning Tools Model U-800 CommercialChecking the Secondary Filter Vacuum AssemblyAttaching the Handle Replacing the Dust BAG Handle Adjustments Automatic SELF-ADJUSTING Carpet NozzleChecking the Exhaust Filter Vacuum OperationsResetting the Thermal Switch ON-BOARD Cleaning ToolsSuction Control Remove the Bottom PlateFor Best Performance Replacing the Drive BeltChanging the Agitator Brushes Model U-900 Cleaning the NozzleIf it should become clogged Model U-800 Advertencias Instrucciones DE SeguridadModelo U-800 Industrial Barredora Industrial Modelo U-800 Y U-900Descripcion DEL Producto Modelo U-900 Industrial Como Instalar Accesorios Modelo U-800 IndustrialRevision DE Filtro DEL Motor Ensamble DE LA AspiradoraEnsamble DE Manija Revision DE Filtro DE Salida Instrucciones DE USO Switch DE EncendidoAjuste DE Altura Automatica Ajuste DE ManijaAccesorios a Bordo Para Reiniciar EL Switch TermicoControl DE Succion Para Quitar LA Tapa InferiorPara UN Mejor Desempeño Cambiando LA BandaCambio DE Cerdas DE Cepillo Modelo U-900 Limpieza DE Conexion DE MangueraSi se tapa Modelo U-800 Centros DE Servicio WarrantyGarantia