Replacing the UV lamp, UV Lamp Safety Warning

300

cleaning & maintenance

Replacing the UV lamp

UV LAMP SAFETY WARNING:

To prevent exposure to ultraviolet light, disconnect power to the unit before servicing any part of the Therapure® 300D air purifier.

Before replacing the UV lamp of your Therapure® 300D air purifier, turn off and unplug the unit from the electrical outlet and read all safety instructions and important warnings in this owner’s manual.

Replace your UV lamp every year. Call 800.875.8577 or visit www.therapureair.com.

1.First turn off and unplug your Therapure® 300D air purifier. With the front of the unit facing up, pull up the lower end of the inlet grill and push it toward the display panel at the top of the unit as shown below.

2. Remove the permanent filter by lifting and pulling the string.

3.Remove the screws on the UV shield by using a screwdriver. Allow the UV lamp to cool at least 15 minutes.

4.Remove UV sheild.

5.Gently rotate the lamp a quarter turn in either direction until it unlocks from the socket. The lamp removes and installs in the same way as a flourescent light lamp.

Pull out the lamp.

6.Unpack the new UV lamp gently

by handling the ends only. Starting at one end of the lamp, then the other, gently insert the metal pins on the lamp into the white slotted socket, one pin at a time. Once the ends of the lamp are completely inserted into the socket, rotate the lamp a quarter turn until it locks

into place.

7.Reinstall the UV sheild according to the following illustration.

8.First, insert the bottom

of the filter into the air cleaner and then insert the top of the filter.

9.Insert the top of the inlet grill first and then snap in the lower part of the grill.

Caution:

Do not touch the glass part of the lamp. Oil from fingertips will decrease the effectiveness of the lamp.

Never operate the unit without a filter or with a damaged filter. The UV light from the UV lamp will result in severe damage to eyes and could cause blindness.

UV Lamp Notice Warning

UV Light is harmful to bare skin and eyes and can cause temporary or permanent loss of vision. Never look directly at the UV lamp while it is illuminated-doing so could cause loss of vision!

To Order a Replacement UV Lamp

If your UV Lamp(s) is broken or needs replacing, simply contact us at 1.800.875.8577 or visit us online at www.therapureair.com.

Therapure® replacement lamp part number is TPG63000.