Outdoor Motion Sensor | PMS03 | ||
|
|
|
|
Detects Motion | LED - Motion Indicator Code Indicator | Manual Off delay |
|
and Dusk/Dawn | Command Indicator | after motion |
|
|
|
Green LED | Wireless RF Signal to | |
Behind Lens | ||
RF Transceiver | ||
|
X10 - Code, On/Off |
|
| Plugs Into | |
Buttons in Battery |
|
| Outlet | |
Compartment |
| PAT01 | *** | |
House/On | Unit/Off | RF Base | Sends | |
Transceiver | X10 | |||
|
| |||
|
|
| Commands |
Description: The Outdoor Motion Sensor, PMS03, is a battery operated, RF Transmitter capable of sensing: Motion and Dusk/Dawn events. It transmits an X10 Command to an X10 PRO RF Base Transceiver (PAT01) which then passes the X10 Command onto the AC wiring of the structure. This can be used to control X10 PRO Receiver Modules, i.e. - Light and Appliance Modules, ON/OFF. The X10 Command can also be used, as a trigger, to initiate Macros in the CM11A, ActiveHome
Specific Requirements:
2 - AAA Batteries, PAT01 - RF Base Transceiver Module
Optional / Supplementary Devices & Modules:
PHH02 - Chime, PLW01 - Wall Switch, PLM01 - Lamp Module
X10 Protocol:
House Code Dial - Letters
Each X10 Receiver Module is set to a unique Unit Number or to an identical Unit Number as desired.
Each X10 Controller operating a specific set of Receiver Modules must be set to the same House Code as the Receivers they are controlling.
Electrical Protocol:
Nearly all residential homes are wired
Installation:
Setting up the PMS03:
1.Remove the battery cover on the front of the PMS03 and install two AAA alkaline batteries. Initially the PMS03 defaults to House Code "A" and Unit Code "1" and defaults to See Motion, all the time (24hrs).
2.
3.Install or
Testing the PMS03:
1.Press the House button once, the PMS03 will transmit an RF X10 ON Command and the Red LED will flash.
2.Press the Unit button once, the PMS03 will transmit an RF X10 OFF Command and the Red LED will flash. (The default setting is "A1" ).
3.Place the Sensor on a shelf or mount it on a wall at least 6 feet above the ground and let it settle for at least 1 minute (default) with no motion before activation.
| PMS03_03_03/07 |
Tampa, FL 33542 | Technical Support: (800) |
|