Haan HD-50 user manual Sweeper Function on Carpet and soft Surfaces, Rear Foot Tab Sweeper Button

Using Your Duo™ Steam Sweeper & Floor Sanitizer

Fig 15

Rear Foot Tab

Fig 16

Sweeper

Button

Fig 17

Fig 18

Fig 19

STEAM	Power Light
Button
Thermal
Indicator

HELPFUL HAAN® HINT:

If you are NOT using the steam function, it is not necessary to place the unit on the Floor Protector Resting Mat.

Operating Instructions: (cont)

Sweeper Function on Carpet and soft Surfaces:

The HAAN® Duo™ can move onto carpeted surfaces easily. The SWEEPER function picks up dirt, while the STEAM function freshens carpets and soft surfaces, killing up to 99.9% of germs, bacteria and dust mites, without chemicals. To use the Duo™ on rugs and carpet, you MUST remove the Pad Tray. The Ultra-Microfiber Pad is NOT used on the Duo™ when using on rugs and carpet, unless you are spot treating (see pg 13 for details).

To use the Sweeper function alone:

1)Before using the unit on carpet, remove the Pad Tray. Place your foot on the rear tab of the Pad Tray (it extends out on the right) (Fig 15). While holding the tray down with your foot, pull up on the pole of the Duo™ until the tray snaps off.

2)Plug the Duo™ cord into a grounded electrical outlet.

3)Press the “SWEEPER” button on top of the Duo™ to start the Sweeper function (Fig 16).

4)Gently press the top of the unit and tip back the handle to a comfortable sweeping position. We recommend a 45˚ angle (Fig 17).

5)Slowly glide the Duo™ back and forth across the floor to pick up loose dirt and particles (Fig 18).

To use the Sweeper and Sanitizer simultaneously:

1)With the unit on the Floor Protector Resting Mat (‘bumpy’ side up), add water to the tank as described in step 2 of the ‘To Refill Water Tank’ instructions on pg 11. Do not overfill.

2)Plug the Duo™ Steam Sweeper & Floor Sanitizer into a standard 120-volt grounded wall receptacle.

3)Press the GREY STEAM ON/OFF power button to turn on the STEAM Function. The STEAM power indicator light on top of the unit will illuminate RED. Your Steam Sweeper and Floor Sanitizer

is heated and ready to use when the Thermal Indicator on the tank cap changes from black to orange (Fig 19).

3)Once the unit is heated and ready to use, press the “SWEEPER” button to activate the Power-Lift Brush (Fig 16). Place the unit on the carpet;

pg 12 877 - HAAN DIRECT / 877 - 422 - 6347 www. H A A N USA . com