Graco Inc 233757 important safety instructions Equipment Misuse Hazard

Page 4

Warning

WARNING

EQUIPMENT MISUSE HAZARD

Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.

•This equipment is for professional use only.

•Read all instruction manuals, tags, and labels before operating the equipment.

•Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.

•Do not alter or modify this equipment. Use only genuine Graco parts and accessories.

•Check equipment daily. Repair or replace worn or damaged parts immediately.

•Do not exceed the maximum working pressure of the lowest rated system component. Refer to the Technical Data on page 20 for the maximum working pressure of this equipment.

•Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the Techni- cal Data section of all equipment manuals. Read the fluid and solvent manufacturer's warnings.

•Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose Graco hoses to temperatures above 180°F (82°C) or below -40°F (-40°C).

•Wear hearing protection when operating this equipment.

•Never use 1,1, 1-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents in pressurized aluminum equipment. Such use could result in a chemical reaction, with the possibility of explosion.

•Comply with all applicable local, state, and national fire, electrical, and safety regulations.

4

309474K

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Low Pressure Model 233757 Shown II 2 GContents List of Models Key to Model DesignationEquipment Misuse Hazard Pressurized Equipment Hazard Introduction Back Pressure RegulatorsFluid Pressure Regulators Fluid Inlet from gunAdjustment screw Spring Diaphragm Valve plunger Fluid Inlet from pump Valve ball and seatFluid Outlet to gun Air inlet Diaphragm Fluid Outlet To gun Valve plungerInstallation Air to gun Fluid Air to pumpG a B Air to Fluid RegulatorAir to Pump GunAir to GunAir to Fluid Regulator Fluid to gun Air Fluid Air to Back Pressure RegulatorPressure Relief Procedure Adjusting the RegulatorOperation Flush Before First UseTroubleshooting Problem Cause SolutionCleaning and Repair MaintenanceFlushing Mechanical Fluid Pressure Regulators Part Nos PartsDescription Mechanical Back Pressure Regulators Part Nos Part No. Description TI11249a Description Qty Pneumatic Back Pressure Regulators Part Nos Technical Data Category DataFlow Rate Data Accessory GaugesGauge Mounting Dimensions Thread Dimension aMounting Dimensions 309474K Graco Warranty For Graco Canada Customers
Top Page Image Contents