TROUBLESHOOTING
Before contacting a dealer or qualified service technician, please read and check the following:
PROBLEM
Unit does not turn on.
Unit running low air flow or cooling.
Unit noisy when operating.
Water leaking from unit.
SOLUTION
1.Make sure city power supply is normal.
2.Check plug is correctly installed into outlet.
3.Check fuses and household breaker switches.
4.Remove electrical plug from outlet. Check electri- cal cord and plug for damage.
5.Check to be sure water tank is installed properly into unit.
6.Check that plug is secure and in place on con- densate tube.
7.Check louvers and grills for obstacles or debris.
8.Check room temperature. Room temperature should not be below 60ÞF (15ÞC) or above 95ÞF (35ÞC).
9.Compressor delay feature may be active. Unplug unit and wait for
1.Check and clean air filter.
2.Check louvers and grills for obstacles or debris.
3.Check MODE and/or THERMO CONTROL selection and adjust for higher air output. (See "OPERATION.")
4.Allow unit to stand upright for a minimum of two hours before attempting to operate.
1.Check that unit is on a flat, level, solid surface.
2.Check filter and tank are installed properly.
3.Turn unit off. Check louvers and grills for obstructions.
4.Allow unit to stand upright for a minimum of two hours before attempting to operate.
1.Check that unit is on a flat, level, solid surface.
2.Check that plug is secure and in place on con- densate tube.