Replacement Instructions

Caution: Be sure to turn the ON/OFF switch to the "OFF " position and disconnect the power cord from the wall outlet before replacing any of the parts below.

REPLACING THE FLAT BELT

1	Remove the bottom plate.
	(refer to page 15)

2 Lift out the agitator assembly,and then remove the flat belt from the motor shaft and the agitator pulley.

Motor Shaft

Flat Belt

Agitator Assembly

3 Place a new flat belt onto the motor shaft and pulley. Motor Shaft

Flat Belt

Pulley

4 Holding two ends of the agitator to place the agitator assembly into the grooves by in the nozzle head, making sure that the new flat belt slides securely into the guide.

Brush Holder

Caution:

Install the flat belt so that it has Groove no twists in it, and so that all

components turn smoothly.

5 Reattach the bottom plate (refer to page 15)