Operation of Your Remote Control
!
WARNING
Fan installation must be completed, including the installation of the fan blades, before testing the remote control.
Your SR600 Fan/Light remote control (Figure 18) has full control of your fan speed, air flow direction and light intensity.
1.If airflow is desired in the opposite direction, press
the (
) button on the wall control. The fan must be operating at any speed for the reverse button to function. The blades will turn in the opposite direction and reverse the airflow.
2.To set the desired fan speed, press the ( 
) button to decrease the speed and the ( 
) to increase the speed. The LED display will light up to indicate the new speed selected.
3.To turn the downlight on, press and release the
(
) button. The light will turn on at the light intensity previously selected.
4.To turn the uplight on, press and release the ( 
) button. The light will turn on at the light intensity previously selected.
5.To vary the intensity of the light, hold the DN or UP button down until the desired light intensity is reached, then release the button.
6.The sixth switch marked ON and I is for dimming control of lights: Set switch to ON to allow for dimming of the lights. Set switch to I for no dimming of the lights such as for fluorescent bulbs.
Installation of Storage Bracket for SR600 Remote Control
A storage bracket is provided for holding your remote control when not in use. If you desire to use the bracket, install it on a wall that is away from excess heat or humidity (Figure 15)
TO INSTALL BRACKET TO WALL:
SLIDE THE COVER UP TO EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER 
WALL
BRACKET
| SCREW | |
| HOLES (2) | |
Figure 15 | ||
|
High Speed Conditioning of Fan Control
IMPORTANT: The following steps must be completed immediately following the frequency programming of the ceiling fan.
1.Press the ( 
) speed button until all 6 LED indicators are lit. Let the fan operate on high speed for 2 minutes without interruption.
2.After 2 minutes, press the reverse (
) button and allow the fan to operate uninterrupted for 2 minutes at high speed.
3.High speed conditioning is now complete.
12 | ETL Model No.: CF921 |