Electrolux CF205BS01, CF205VS01, CF205GES01 owner manual Ets from light kit plate Figure

How to Disassemble Your Light Kit for Cover Plate Assembly Only

! WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver.

1.Detach the light kit plate from the fan motor/hous- ing assembly by removing one screw and loosen- ing the two other screws (located in the keyholes). Rotate the light kit plate counter- clockwise to dis- engaging the screws in the two key hole slots (Figure 18).

1.Detach the light kit plate from the fan motor/hous- ing assembly by removing one screw and loosen- ing the two other screws (located in the keyholes). Rotate the light kit plate counter- clockwise to dis- engaging the screws in the two key hole slots (Figure 18).

3. Cut light socket wires using wire cutters. Unscrew

the screws that is securing the socket plates to the

light kit plate. Pull socket wiring though light kit

plate holes to completely disengage the light sock-

WHITE WIRES

FAN MOTOR/

HOUSING

ASSEMBLY

BLUE WIRE

BLACK WIRE

Figure 18 LIGHT KIT PLATE

CUT LIGHT

SOCKET WIRES

CUT LIGHT SOCKET WIRES

ets from light kit plate (Figure 19).

Figure 19

LIGHT KIT PLATE

REASSEMBLE

LIGHT KIT

PLATE

REMOVE SOCKET/

SOCKET PLATE (2)

Figure 20

REASSEMBLE MOTOR SCREW (3)

REMOVE SOCKET PLATE SCREWS (2 per plate)

11 U.L. Model No.: CF205