Infiniti TSS-800, Infinity Total Speaker Solutions manual Bracket on wall

Adjustable Wall Bracket

Step 1. Mark the positions on the wall where you would like to place the mounting screws.

Step 2. Place bracket against the wall and fasten four 1-1/2" #10 wood screws through the bracket’s screw holes into the wall. If a wall stud is not available, use an appropriate anchor.

Step 3. Unscrew round collar (C) from bracket (A).

Step 4. Screw the ball and shaft assembly (B) to the lower 1/4"-20 insert on the rear of the satellite, or the upper insert on the rear of the center channel. Back out 1/2 of a turn and tighten the nut against the speaker.

Step 5. Attach speaker wire as shown on page 4.

A

B

C

Step 6. Drop round collar (C) over ball and shaft assembly (B) that is mounted to the speaker with the finished side of the collar facing the rear of the speaker.

Step 7. Carefully push the ball straight into the socket mounted on the wall, angle the speaker as desired and tighten the collar using the enclosed metal bar.

Metal bar

Figure 3. Bracket on wall.

3TSS-800 (230V)