1. | Assembly of the Upper Channel, to | 3a. | Completing the Installation (cont’d) | |
| Cabinet. (Factory installed on some models) | • | Carefully place the air conditioner into the | |
|
|
| ||
• | "L" Shaped Top Channel: Install the "L" |
| window with the “L” shaped mounting bracket | |
| (on top) positioned in front of the upper window | |||
| shaped channel to the top of the cabinet as |
| sash. The bottom of the cabinet should be | |
| shown in Fig. 3 using four (4) 3/8" (9.5mm)screws. |
| positioned on the “recessed” portion of the | |
|
| 3/8" (9.5mm)Screw |
| window frame. Pull the window down until it |
|
|
| rests just behind the front flange of the (top) “L” | |
|
|
|
| |
|
|
|
| shaped mounting bracket. See Fig. 5. |
|
|
| • | Expand the shutter frames (fully) on each side |
|
|
|
| and secure the top of the frames to the window |
|
|
|
| sash using one 3/4" (19.1mm)screw on each side and |
|
| “L” Shaped |
| one in the “L” shaped mounting bracket. Fig. 5 |
|
| Mounting Bracket |
|
|
|
|
| • | Secure the shutter clamp on each side of the |
|
|
|
| (lower) shutter and secure to window sill using |
|
| “U” Shaped Channel |
| one 3/4" (19.1mm)screw on each side. Fig.5 |
Fig. 3 |
|
| ||
(Factory Installed) |
|
| ||
|
|
|
| |
2. Assembly of the Side Curtains to |
| Window Sash | ||
| Cabinet. |
|
|
|
• | Extend the shutter from the shutter frame and |
|
| |
| slide it into the shutter guide on the side |
| 3/4" (19.1mm)Screws | |
| channel of the air conditioner as shown in Fig. 4. |
|
| |
• | Slide the shutters into the top (“L” Shaped) and |
|
| |
| bottom (“U” Shaped channels. The shutters are |
|
| |
| identified (on frame) as left & right. |
| “L” Shaped | |
|
|
|
| |
|
|
|
| Mounting |
|
|
|
| Bracket |
|
|
|
| Fig. 5 |
|
|
|
| Shutter clamps |
|
|
| Place the second foam sealing strip to fit the | |
|
|
| opening between the inside and outside windows | |
|
|
| then attach the safety lock to the outside | |
|
|
| window frame using one 3/4”(19.1mm) screw. See. Fig. 6 | |
|
|
|
| Safety Lock |
|
|
|
| Foam Seal |
| Shutter |
|
|
|
| Shutter Frame | Fig. 4 | 3/4" (19.1mm)Screw | |
|
| |||
|
|
| ||
3. | Completing the Installation |
| Fig. 6 | |
|
| |||
• | Cut the foam (non adhesive) sealing strip to | PLEASE NOTE: Window applications come in a |
| fit the area of the window sill that the air | variety of different styles. Therefore, it may be |
| conditioner will rest on. | necessary to modify or improvise your particular |
|
| installation. |
|
| 6 |