Identification, Manufacturer | Blizzard Entertainment 1000 specification

FORLI' Italy

1.0IDENTIFICATION

The identification plate of the machine is affixed outside the plate casing (see fig. 1).

1.1MANUFACTURER

WTA srl

Via Virgilio, 3

47100 FORLI' - ITALY P. IVA 00718330400

1.2DEFINITIONS

In this handbook, three types of “safety graphics” are used to point out different levels of danger or any other important information:

DANGER

Draws the attention to potentially dangerous situations which may cause serious personal injury.

CAUTION

Draws the attention to potentially dangerous situations which may cause personal injury or material damage.

1.3.3OVERALL DIMENSIONS

See fig. 2:
		Model
		1000-1300
A	mm	940
B	mm	695
C	mm	225
D	mm	300
E	mm	640
F	mm	340

1.3.4HANDLING

The packed air conditioner can be handled by normal means of lifting and transport.

Boxes are fitted with spacers which enable the use of manual fork-lifts.

DANGER

Strictly observe the accident prevention precautions and safety regulations during lifting and transport, and always use machines with a higher maximum capacity than the load to be lifted.

2.0INSTALLATION

IMPORTANT

Draws the attention to situations which may cause malfunctioning or damage to the machine.

1.3TRANSPORT - HANDLING - STORAGE

1.3.1STORAGE CONDITIONS

The air conditioner is protected against sudden impact by suitable packing consisting of cardboard, polystyrene and a wooden frame support.

The air conditioner should be stored horizontally in a dry and well-ventilated room.

1.3.2 WEIGHT
Gross weight (including packing):
Mod. 1000	Kg	26
Mod. 1300	Kg	28

2.1AUTHORISED PERSONNEL

The air conditioner shall be installed onto the vehicle -i.e. camping-cars, caravans, motorhomes, only and exclusively by skilled technicians or workshops, authorized by W.T.A.

According to the vehicle dimensions and to the real air conditioning needs one or more units can be installed.

If the installation is carried out by non-authorized technicians or workshops, W.T.A. disclaims any responsibility for the unit safety and efficient running according to the M.D. 89/392/EC.

DANGER

The instructions given in sections 2.2 are addressed to qualified technicians only.

2.2MOUNTING THE AIR CONDITIONER

BLIZZARD air conditioners can be installed on openings with following sizes: 35x35 cm. up to 40x40 cm max. It is possible to use an existing air inlet or drill a new one. In such case, make sure that the roof can tolerate the air conditioner weight and, in case, stiffen it suitably.

Remove the skylight cover (fig. 3).

Carefully clean the surfaces around the installation opening, remove any waste, and fill any surrounding hole