CONNECTbNG/ S Z a Cmng Power TOURmAMPSi

i CONNECTbNG/ S Z A CMNG POWER TOURmAMPSi

If you have a second POWER TOURTM amp (sold separately). you can c two amplifiers. Doing so doubles your sound!

Take the cable that came with the second POWER TOURTM AMP, and plug on

into the "OUT" jack of the first amplifier: plug the other end of this cable into the I!'IN1" jack of the second amplifier.

Once you have the two POWER TOURTM AMPS connected, you may plac amplifier on top of the other amplifier: you'llsee that the four pads on t

of one amplifier fit comfortably into four tabs on the top of the other amplifier.

This does not lock the two amplifiers together:so be careful not to knock or push them over!

Controlthe tone and volume of each amp with each amplifier'sTone and ~olum& knob. If you have two or more amps connected together, it is a good idea to set each amp at the same volume: this equalizes the sound.

Use the Volume knob on your guitar (not included) to control guitar output. If you kt, ant to play loud, set each amplifier at the same high volume, then turn up the volume of your guitar: use the Tone knobs. on each of the amps to adjust for the

best sound.

'Auto-Off'Feature

If you don'tplay any music through the amplifier for about 15 minutes. the amplifierwill enter a 'sleepstate"

(conservingbattery life, should you forget to turn the amplifier off).To wake the amp back up. play some music through the amplifier. (The amplifier might not pick up low-volumemusic, so you might have to play a couple of loud notes.) You could also switch the power switch off, then back on again, to wake up the amplifier. If you'renot

going to play through your amplifier for a while. however, it'sbest to turn it off, to conserve battery life.