Troy-Bilt 24A-070F768 warranty Attaching The Blower Chute, If Equipped

Page 9

Attaching The Blower Chute

(If Equipped)

NOTE: The bag must be removed before installing the blower chute.

8.a. Grasp blower chute with one hand and slide locking rod on mounting bracket with other hand toward engine. Use the end of mounting bracket as lever- age when sliding the locking rod. See Figure 8.

b.Slip blower chute over rim of discharge opening and release locking rod to secure chute in place.

c.Raise the nozzle height to the highest setting when using the blower chute. Refer to nozzle height adjustment in the MAINTENANCE section on page 16.

NOTE: The bag/chute switch button attached to the mounting bracket must be fully depressed by the tip of front tab on the blower chute or engine will not start.

�

�

Figure 8

3

Setting Up

Your Yard

Vacuum

NOTE: The bag must be removed before installing the blower chute.

9

Image 9

Contents 27/2005 OPERATOR’S ManualTable of Contents Finding and Recording Model NumberCustomer Support Your Responsibility Restrict the use Safety LabelsSafe Operation Your Responsibility Do not modify engineOpening Carton Setting Up Your Yard VacuumRemoving Unit From Carton Loose Parts In CartonAttaching The Handle Attaching The Hose AssemblyAttaching The Bag VacuumIf Equipped Attaching The Blower ChuteKnow Your Yard Vacuum Operating Your Yard VacuumGas And Oil Fill-Up Starting EngineStopping Engine Operating Using The Nozzle VacuumTo Empty Bag To Remove Blower ChuteUsing The Hose Assembly Nozzle Height Adjustment Engine MaintenanceMaintaining Your Yard Vacuum LubricationRemoving The Flail Screen Drive Control Cable AdjustmentSharpening Or Replacing Chipper Blade Disconnect and ground the spark plug wire to retaining postStoring Your Yard Vacuum Problem Cause Remedy For parts and/or Accessories Please call Model Saddle Washer, .320 To order replacement Parts, contact Or visitModel 40 -0962 Compression Spring 41 -0778A Mounting Bracket Bag AssemblyU.S.A Canada MANUFACTURER’S Limited Warranty for