Maintenance

Figure 7

Figure 8

Dust Bag

Part #5093 AM

Micro-Hygiene

Filter

Part #5036 AM

Always unplug vacuum from outlet

!before dismantling any part of machine!

Changing the Dust Bag - Figure 7

To change the dust bag, pull the cover release flap forward (#5 on page 5) and lift the cover (7) from the dust bag housing. The cover release flap must remain in a for- ward “pulled-out” position to change dust bags and lock them into place. Squeeze the clamps on both sides of the dust bag sealing plate, slide the plate (28) from the holder (29) and push the cap on to seal the bag. Slide the sealing plate (28) of a new bag into the holder and push it in firmly. Re-insert cover into dust bag housing, push it for- ward, then lock it in place by pushing down the cover release flap. You may find it convenient to store the bag cap inside the dust bag housing below the dust bag.

Figure 9

Figure 10 (X4)

Brush & Edge Rollers (X5) Part #5290 AM

Figure 11 (X4)

Exhaust Filter

Part #5143

Brush Roller (X4)

Part #5010 AM

Figure 10a (X5)

Sealing Strip

Part #5400-1 (X4)

Part #5400-2 (X5)

Figure 11a (X5)

Changing the Micro-Hygiene Filter -

Figure 8

The micro-hygiene filter (30) needs to be changed when it becomes extremely dirty or clogged with dust, or after approximately 20 dust bags have been used. To change the micro-hygiene filter, pull the cover release flap (#5 on page 5) forward and lift the cover from the dust bag hous- ing. Then, slide the filter out at the bottom. To replace, lift the safety lever (31) and slide the new filter in using the tracks as guides.

Changing the Exhaust Filter - Figure 9

After 20 bags have been used, change the exhaust filter (32). To remove the exhaust filter, push the catch (33) backward and remove the filter cover (34) and exhaust fil- ter. Insert the new filter and replace the filter cover.

Changing the Brush Roller(s) -

Figure 10 (X4), Figure 10a (X5)

To change the brush roller(s) (35 or 35a), push the but- ton(s) (36 or 36a), remove the side plate(s) (37 or 37a), turn the brush(s) clockwise a quarter of a turn, and pull the old brush roller(s) out. Slide the new brush roller(s) into the brush housing and turn it until it locks into posi- tion. While slightly pushing the button(s) (36 or 36a), press the side plate(s) (37 or 37a) back into the locked position.

Changing the Sealing Strip -

Figure 11 (X4), Figure 11a (X5)

The sealing strip (39) is located just behind the brush roller opening. The sealing strip seals the power head to hard floors to prevent kick-back of debris while vacuum- ing. To replace a worn sealing strip, push the release but- ton, remove the side plate (36 and 37 in figure 10 & 10a) and slide old strip out. Insert the new strip into the slot and slide into place.

Page 8