Identification of Parts
25
17 16
26
1.Handle grip
2.On/Off switch
3.Handle assembly
4.Retaining ring
5.Cover release flap
6.Dust bag housing
7.Front cover
8.Housing release button
9.Power head with brush
10. Cable (cord)
11. Attachment tube handle
12. Attachment hose
13. Carrying handle
41 42
46
43
45 
44
Standard Attachments
16.Crevice nozzle
17.Upholstery nozzle
25.Dusting brush clamp
26.Dusting brush
26
Attach dusting brush clamp with screw
25
Note
All illustrations shown in this manual repre- sent the G1 model except where part numbers and instruc- tions are
different for each model. In those instances, illustrations for both the G1 and G2 will be shown.
14.Cable (cord) hook
15.Attachment tube (active wand)
16.Crevice nozzle
17.Upholstery nozzle
18.Pile adjustment knob
19.Foot pedal
20.Swivel neck
21.Support lever
22.Handle release catch
23.Projection tab
24.Connecting tube
25.Dusting brush clamp
Optional Attachments
41.Wall and floor brush - Part # 1325 HG
42.Turbo brush for stairs - Part # 6179 AM
43.Radiator brush - Part # 1496 HG
44.Extension hose (9’3”) - Part # 1495 AM
45.Straight tube - Part # 1084 HG
46.Flat upholstery nozzle - Part # 1090 HG
Also available for odor control - the combined micro/charcoal filter - Part # 5425 AM
Assembly
Place the power head (9) on the floor with the swivel neck (20) and the support lever
(21)upright. Hold the dust bag housing (6) vertically and place it over the swivel neck and support lever. Push firmly and evenly down so that the housing release button (8) snaps outward to its “locked” position.
Slide the dusting brush clamp (25) onto the handle tube (3) and tighten the screw. The handle of the dusting brush (26) will now snap into the clamp.
To insert the handle tube (3) into the hous- ing, lift the catch (22), slide the handle in, making sure that the handle is all the way in and cannot go any further. Push the catch
(22)down to lock handle in place. If the han- dle is not pushed fully down, the vacuum will not work.
Push the black end of the attachment hose
(12)into the connecting tube (24) so that it clicks into place. Insert the attachment tube
(15)into the swivel neck and push the han- dle (11) over the projection tab (23).
Insert crevice nozzle (16) and upholstery nozzle (17) into the recesses in the back of the machine.
Page 5