Stanley Black & Decker 2005 Series Duress feature can be turned off as follows, Managing Duress

Operating Instructions

S&G® Z03 D-Drive™Multi-User Electronic Safe Lock

2005 Series

➥Cancelling User Disable in Management/Employee Access Mode

If you decide user code holders should no longer have the ability to disable the lock, perform the following procedure.

56 ✽ master code #♪♪♪♪♪0 #♪♪♪0 #♪♪♪

User code holders will no longer be able to disable the lock, although the master code holder and supervisor code holder will still have the ability to do so.

➥Taking the Lock Out of Management/Employee Access Mode

If you no longer want the lock to function in the management/ employee access mode, enter the following sequence.

32 ✽ master code or supervisor code #♪♪♪♪♪1 #♪♪♪1 #♪♪♪

The lock will now operate on any valid code at any time.

Managing Duress

➥Turning Duress ON

If your lock was ordered with time duress capability and an optional duress module is installed, the feature can be turned on as follows.

38 ✽ master code #♪♪♪♪♪1 #♪♪♪1 #♪♪♪

➥Turning Duress OFF

The duress feature can be turned off as follows.

38 ✽ master code #♪♪♪♪♪0 #♪♪♪0 #♪♪♪

➥Verifying Duress

If duress is enabled, you can tell if the lock has sent a silent alarm. Fifteen minutes or more after a duress signal has been sent, press and hold down the ✽ button for at least four seconds. The lock will emit a continuous alternating series of high and low pitch beeps to indicate that a duress signal has been sent. Reset the duress indication by entering the lock’s master code within one minute after the verification signal ends.

Managing Audit Trail

➥Capturing an Audit Trail

Your lock must have been ordered with this option. Using the audit trail feature also requires an optional keypad extension (S&G part number 6101-201), as well as an audit trail software kit (S&G part number 6103-100). The lock records the last 63 events, in the order they occurred. After the 63rd event, the lock overwrites the oldest event with the new one, so you always have access to the most recent 63 events. To download the audit trail through the optional keypad extension, hold the Dallas iButton key provided in the audit trail kit to the receptacle in the keypad extension, and enter the following.

2 8 ✽ master code #

The lock will beep three times when the download is complete. You may then remove your iButton key from the keypad extension’s receptacle. The information now stored in the key is a copy of what is in the lock. The lock’s audit information is not erased in the download process.

© Copyright 2006, Sargent & Greenleaf Page 7