Stanley Black & Decker 2005 Series manual Battery Changing Instructions

Page 10

Battery Changing Instructions

S&G® Z03 D-Drive™Multi-User Electronic Safe Lock

2005 Series

Step 4—Carefully slide the battery behind the keypad, into the cavity that is designed to hold it (Figure 4). Be sure the battery has dropped all the way to the bottom of the cavity.

Step 5—Gently place any excess wire into the cavity. Make sure it is not in a position to be caught between the keypad ring and the keypad base when the ring is pushed back against the base (Figure 5).

Step 6—Once the wires are safely positioned out of harm’s way, push the keypad ring back up against the base, then turn it clockwise until the yellow tab snaps back into its normal position (Figure 6).

Check your lock operation at least three times with the container	Figure 4
door open before closing it.

Figure 5

Figure 6

Page 10

Image 10

Contents After ten minutes, the lock should operate normally SeriesLock 5 5 5 5 5 5 # or J J J J J J # IntroductionTo Open the Lock Case of TroubleEnter 9 8 7 6 5 4 # Enter 1 2 3 4 5 6 #Enter 1 2 3 4 5 6 # 9 8 7 6 5 4 # Here is the process for creating a supervisor code Any code holder can change his own code. The process is2 2 2 2 2 2 #2 4 6 8 3 3 #2 4 6 8 3 3 # Changing, Creating, Deleting CodesHere is the process for deleting a supervisor code Managing Time DelayMaster code # 0 1 # New TDO code #new TDO code # Management/Employee Access ModeTDO code is deleted as follows Master code or supervisor code #Managing Audit Trail Duress feature can be turned off as followsManaging Duress Master code #Information Tables Low Battery ConditionEnter 4 Beep Pattern EmittedBattery Changing Instructions Battery Replacement ProcedureBattery Changing Instructions Page Warranty