GENERAL MAINTENANCE
UNPLUG THE UNIT BEFORE PERFORMING ANY MAINTENANCE PROCEDURES Recommended Monthly Maintenance
•Clean the
•Clean the HEPA Filter
CLEANING THE PRE-FILTER & THE HEPA FILTER
When visibly dirty or after 30 days:
1.Unplug the power to the unit.
2.Remove the
3.Remove the HEPA filter by pulling on its ribbon handle. (Diagram 2)
4.With a
5.
6.
If vacuuming does not clean the filters sufficiently:
1.Rinse both filters in warm water. NOTE: DO NOT use soap, soak in water, scrub with brush, or squeeze the filters.
2.Shake the excess water off of the filters.
3.Allow both filters to dry thoroughly before
4.
5.
Contact your dealer for replacement filters:
1.Contact the dealer you purchased your product from or visit www.rppurchase.com to locate your closest dealer.
CHANGING THE UV LAMP
1.Unplug the power to the unit.
2.Remove the
3.Remove the HEPA filter by pulling on its ribbon handle. (Diagram 2)
4.Carefully roll the UV Bulb until it is loose (bulb fitting is similar to a fluorescent bulb). (Diagram 3)
5.Remove the UV Bulb. (Diagram 4)
6.Insert new UV Bulb making sure the ends slide into their slots.
7.Carefully roll the UV Bulb until it is not loose. (Diagram 3)
8.
9.
10.Plug the power back in and then turn on the UV setting to make sure the bulb is functioning properly. If it doesn’t light up, repeat the above steps again to make sure the bulb is properly installed into its slots.
Diagram 1 | Diagram 2 | Diagram 3 | Diagram 4 |
14