Wayne-Dalton 8000, 9000 Installing the ECR Lock, Series doors see , place the lock section

Fig. 3

Fig. 2

Fig. 1

1/2 THE

SECTION

HEIGHT

Step 1: Installing the ECR Lock

CAUTION DO NOT DRILL LOCK

SECTION OR INSTALL LOCK ON DOORS WITH OPENERS. THE DOOR AND/ OR OPENER MAY BE DAMAGED IF THE OPENER IS USED WHILE THE DOOR IS LOCKED.

NOTE: Common practice for doors with the odd number of raised panels is to mount the lock towards the right side of the section when looking out.

IMPORTANT: Remove all burrs from the drilled holes before installing the lock to the section.

8000/8100/8200/PR9000 & PR9050 Series doors (see Fig.1), place the lock section face down on (2) padded sawhorses for a single car door or (3) padded sawhorses for a double car door. Locate the (3) hole pattern in the center stile of the lock section. Use the (3) holes as a template to drill (3) 1/8” diameter holes through the section. Flip the section over, face up. With the section face up, enlarge all (3) holes to 3/4” diameter, pay close attention not to drill complete through section into center stile.

NOTE: Do not drill through or enlarge holes in the center stile.

8300/8500 Series & Wood doors (see Fig.2), place the lock section face up on (2) padded sawhorses for a single car door or (3) padded sawhorses for a double car door. Locate the middle of the center stile, measure the distance from the end of the section to the middle of the center stile. Turn the section face down, transfer the measurement and mark a light vertical line, then mark a horizontal line at half the section height. Align the 7/16” diameter hole of the lock backup plate at the intersection point of the horizontal and vertical marks, use the lock backup plate as a template to mark the (3) holes, remove the lock backup plate and drill (3) 3/4” diameter holes through the section.

CENTER STILE

(3)PRE-PUNCHED HOLES

(3) 3/4” DIA.

HOLES FACE UP

FACE DOWN

VERTICAL

MARK

HORIZONTAL MARK

7/16” DIA.

HOLE

(3) 3/4”DIA.

HOLES

LOCK BACKUP	FACE DOWN
PLATE

VERTICAL

MARK

(3) 3/4”DIA.

HOLES

LOCK STILE FACE DOWN

9000 Series doors (see Fig.3), place the lock section

face up on (2) padded sawhorses for a single car door or

(3) padded sawhorses for a double car door. Locate the

middle of the center stile, measure the distance from the end of the section to the middle of the center stile. Turn the section face down, transfer the measurement and mark a light vertical line. Align the center of the lock stile with vertical mark, use the lock stile as a template to mark the (3) holes, remove the lock stile and drill (3) 3/4” diameter

holes through the section. 2