Wayne-Dalton 9000, 8000 Outside Lock Handle Assembly, Inside Handle Assembly

Step 2: Outside Lock Handle Assembly

8000/PR9000 & PR9050 Series doors (see Fig. 4),

align the outside handle assembly with the handle pointing towards the floor and insert the assembly through the previously drilled 3/4” diameter holes in the section. Secure the outside lock handle to the section with (2) #10 phillips head screws.

9000 Series & Wood doors (see Fig. 5), align the outside handle assembly with the handle pointing towards the floor and insert the assembly through the previously drilled 3/4” diameter holes in the section. With the outside lock placed in the section, place the center lock stile over the shank of the outside lock handle, secure the center lock stile with foam tape (8300/ 8500 Series & Wood doors will use the lock backup plate with no foam tape). Secure the outside lock handle

3/4” DIA.

HOLES

OUTSIDE

HANDLE

HANDLE

SHANK

Fig. 4	#10 PHILLIPS
	HEAD SCREWS
	HANDLE

FOAM TAPE SHANK

OUTSIDE

HANDLECENTER STILE

to the section by placing the (2) #10 phillips head machine screws through the lock stile into the lock section. NOTE: Before proceeding to the next step its recommended that the outside handle be locked.

Step 3: Inside Handle Assembly

3/4” DIA.

HOLES

Fig. 5

#10 PHILLIPS HEAD SCREWS

8000/8100/8200 & 9000 Series doors (see Fig.6), position the inside handle over the shank of the outside handle, flush against the center stile. Align the holes in the handle with the pre-punched holes in the center stile, then turn the handle clockwise to secure with (2) #8 screws.

8300/8500 Series & Wood doors ( see Fig.7), position the inside handle over the shank of the outside handle, flush against the lock backup plate. Align the holes in the handle with the pre-punched holes in the lock backup plate, then turn the handle clockwise to secure with (2) #8 screws.

NOTE: When securing the inside handle bracket, be sure not to over tighten the screws or damage to the inside handle may occur.

NOTE: Follow the Main Installation Instruction Manual to install the door sections and vertical track before you install the remainder of the lock parts. After the sections and track are installed, continue with Step 4.

PRE-PUNCHED HANDLE

HOLES

SHANK
INSIDE
HANDLE CENTER
STILE	(2) #8 SCREWS

Fig. 6

BACKUP PLATE

PRE-PUNCHED

HOLES

SHANK

	HANDLE
INSIDE	(2) #8 SCREWS
HANDLE

Fig. 7

3