Vax
www.vax.co.uk
6.Belt or brushbar: removal and replacement
TOOL REQUIRED: Phillips screwdriver
! | WARNING:to reduce the risk of injury from moving |
parts - unplug cleaner beforechanging belt or brush. |
To remove belt
Lay cleaner flat and flip cleaner to expose nozzle base. Base should lay flat and face up. To remove nozzle guard, use Phillips screwdriver to remove the three (3) screws. Arrows show location of screws.
To replace belt or brushbar
Slide belt onto motorshaft.
MOTOR SHAFT
Fig.6/4
Place new belt in area of brushbar without bristles.
Fig.6/1
Fig.6/5
Flip cleaner right side up. Rotate nozzle guard forward and lift off.
Fig.6/2
Lift and remove brushbar. Dispose of old belt.
With new belt in place, pull and slide brushbar into nozzle making sure that the brushbar end caps are in the correct orientation (Fig. 6/5 inset). Rotate brushbar manually to make sure belt is properly aligned.
Fig.6/6
Fig.6/3