Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Operation
Important. For first time operation of spotlight, the average charge time is 15 hours.
Charge time after first use is 12 - 15 hours.
If unit is not used for two months, it is suggested the battery be recharged for approx 4 hours and repeated every 2 months of non use.
Important. Do not charge with AC and DC chargers at the same time.
AC Power Charging
CAUTION. Use only with AC Charging Adapters that are approved with unit.
Important. Before plugging in the power supply from the charger to the spotlight always ensure that the plug is switched off at the main as well as the spotlight and trigger switch is in the off position.
1.Connect the power supply from the charger to the spotlight via the barrel connecter .Plug into the recharge port socket at the base of the housing (5).
2.Plug in the charger and switch on. The LED indicator
(4)will show power and
that charging is taking place.
3.Charge for approximately 12 – 15 hours maximum or until the green LED is lit.
4.Turn off the charger power supply from the main. Disconnect the barrel connecter from the recharge port
(5). Wait 5 minutes before use. Store adaptor in a safe place.
Do not overcharge – Charge until LED light green status (max 12 – 15 hours).
Important. Do not operate when charging.
DC Power Charging
CAUTION. Use only with DC Charging Adapters that are approved with unit.
Important. The DC source (jump starter, battery pack, vehicle accessory socket, etc.) must be 12 Volt DC and should be able to supply at least one half Amp at 12 VDC for 10 hours. This means a battery pack should be charged with at least 5 Amp hours capacity.
1.Plug the DC fused recharge adapter (10) into the recharge port at the base of the housing (5).
2.Insert the power plug into the accessory socket of your power source. The LED indicator (4) will show power and that charging is taking place.
3.Charge for approximately
4.Disconnect charger from power supply. Unplug the barrel connecter from the recharge port (5) Wait 5 minutes before use. Store adaptor in a safe place.
Do not overcharge – Charge until LED light green status. DO NOT charge for more than 24 hours with DC charger.
Note. Some vehicles must have the ignition switch on to power the vehicle accessory outlet.
9