LENS HOLDER | PIVOTING HEAD |
|
| POWER PACK (NOT INCLUDED) | |
TÊTE PIVOTANTE |
|
| ENSEMBLE DE PILES | ||
SUJETADOR DE LA LENTE | CABEZA GIRATORIA |
|
| (NON COMPRIS) | |
|
|
|
|
| BATERIA (NO INCLUIDA) |
|
|
|
|
| |
|
|
| SWITCH |
| |
|
|
|
|
| |
|
|
| INTERRUPTEUR |
|
|
|
|
| INTERRUPTOR |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FIG. 1
BULB
AMPOULE
BOMBILLA
BATTERY RELEASE BUTTON
BOUTON DE DÉGAGEMENT DE LA PILE
BOTON DE LIBERACION DE LA BATERIA
SPARE BULB STORAGE
RANGEMENT DE L’AMPOULE DE RECHANGE
COMPARTIMIENTO PARA BOMBILLA DE REPUESTO
FIG. 2
FIG. 3
objects can contact exposed battery terminals. 
For example, do not place battery in aprons, pockets, 
tool boxes, product kit boxes, drawers, etc. with loose 
nails, screws, keys, etc. without battery cap. Without 
cap in place, battery could short circuit causing fire or 
burns or damage to battery.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Charging Procedure
Chargers require no adjustment and are designed to be as easy as possible to operate. Simply place your battery pack into the receptacle of a plugged in charger and it will automatically charge the pack.
15 MINUTE CHARGER
1.Plug the charger into an appropriate AC power outlet. The charger will beep twice, the red light will blink and go off.
2.Insert the battery pack into the charger, making sure the pack is fully seated in the charger. The red light will blink and the charger will beep once indicating the charging process has started.
3.The battery pack will be fully charged in less than 15 minutes under most conditions. This will be indicated by the red light remaining ON and 3 beeps. The pack is fully charged and may be used at this time or left in the charger.
Weak Battery Packs: (DW9115). The charger can also detect a weak battery. Such batteries are still usable but should not be expected to perform as much work. In such cases, about 10 seconds after battery insertion, the charger will beep rapidly 8 times to indicate a weak battery condition. The charger will then go on to charge the battery to the highest capacity possible.
ONE HOUR CHARGERS
1.Plug the charger into an appropriate AC power outlet.
2.Insert the battery pack into the charger, making sure the pack is fully seated in the charger. The red (charging) light will blink continuously indicating that the charging process has started.
3.The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be used at this time or left in the charger.
Leaving the battery pack in the charger: When the red light remains ON, the charger has switched to its "equalize charge" mode which lasts approximately 4 hours, after which the charger will switch to "maintenance charge" mode. The battery pack can be removed at any time during these charge cycles, but will only be fully charged if the red light is continuously ON. The charger and battery pack can be left connected with the red light glowing indefinitely. The charger will keep the battery pack fresh and fully charged. A battery pack will slowly lose its charge when kept out of the charger. If the battery pack has not been kept on maintenance charge, it may need to be recharged before use. A battery pack may also slowly lose its charge if left in a charger that is not plugged into an appropriate AC source.
Trouble Indicators: These chargers are designed to detect certain problems that can arise with battery packs which would be indicated by the red light flashing at a fast rate (and continuous beeping for DW9115, DW9107, DW9108). If this occurs,
PROBLEM POWER LINE (DW9107)
When these chargers are used with some portable power sources such as generators or sources that convert DC to AC, the chargers may temporarily suspend operation, flashing the red light with two fast blinks followed by a pause. This indicates the power source is out of limits.
Battery Insertion and Removal
To insert the power pack into your flashlight, slide it into the end of the light until it snaps into place. To remove the power pack, depress the release buttons shown and withdraw the power pack.
If you have any questions, call