Getting Started
Thank you for purchasing the iP39. Designed specifically to work with your iPhone and iPod, this system provides high quality audio performance that brings out the best in your music and lets you wake, sleep or even cook to it.
Please read this instruction carefully before the appliance is operated and keep it for future reference.
Connect AC Adaptor
Connect the AC adaptor cable plug into the DC jack on the back of the system, then plug the AC adaptor into the wall outlet.
Install Clock Backup Battery
The iP39 uses a CR2032 battery for backup to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings. The battery was included in the package with this instruction manual.
1.Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement.
2.Open the backup battery compartment door located on the rear of the unit.
3.Insert a new CR2032 battery by easing it under the tabs in the battery well and pressing down. Make sure the side
marked + is facing up. Close the compartment door.
Note: The 
Icon is located at the left side of clock display. When battery is low and needs to be replaced, the “Battery Low” 
icon will flash.
4.Close the compartment cover.
Note: Make sure you dispose of battery properly (see your local regulations).
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high temperatures. Do not place loose batteries in a pocket, purse, or other container containing metal objects, mix with used or other battery types, or store with hazardous or combustible materials. Store in cool, dry, ventilated area. Follow applicable laws and regulations for transport and disposal.
Install iPod/iPhone Inserts
Your iP39 comes with a set of inserts to ensure your iPhone or iPod fits properly in the dock found at the foot of the system. To place an insert:
1.Push dock drawer to access dock
2.Select the insert for your iPhone/iPod (see table on page 1).
3.Gently press the iPhone/iPod insert into the dock.
4.Carefully place your iPhone/iPod into the dock. The iPhone/iPod must not be in a case or “skin”.
5.To remove/replace an insert, first remove your iPhone/iPod then press down the insert latch, grip the insert and pull gently upwards.
3