First Alert FCD4 Limited Warranty General Limitations of CO Alarms, Frequently Asked Questions

Page 6

UL2034 Information Continued...

Standards: Underwriters Laboratories Inc. Single and Multiple Station carbon monoxide alarms UL2034.

According to Underwriters Laboratories Inc. UL2034, Section 1-1.2: “Carbon monoxide alarms covered by these requirements are intended to respond to the presence of carbon monoxide from sources such as, but not limited to, exhaust from internal-combustion engines, abnormal operation of fuel-fired appliances, and fireplaces. CO Alarms are intended to alarm at carbon monoxide levels below those that could cause a loss of ability to react to the dangers of Carbon Monoxide exposure.” This CO Alarm monitors the air at the Alarm, and is designed to alarm before CO levels become life threat- ening. This allows you precious time to leave the house and correct the problem. This is only possible if Alarms are located, installed, and main- tained as described in this manual.

Gas Detection at Typical Temperature and Humidity Ranges: The CO Alarm is not formulated to detect CO levels below 30 ppm typically. UL tested for false alarm resistance to Methane (500 ppm), Butane (300 ppm), Heptane (500 ppm), Ethyl Acetate (200 ppm), Isopropyl Alcohol (200 ppm) and Carbon Dioxide (5000 ppm). Values measure gas and vapor concentrations in parts per million.

Audible Alarm: 85dB minimum at 10 feet (3 meters).

FREQUENTLY ASKED QUESTIONS

Why doesn’t the Alarm respond when I test it and the POWER/ALARM light is OFF?

The CO Alarm is not receiving power. It may not be plugged in all the way and the battery may be missing, low, or dead. Gently push the unit all the way into the outlet, and make sure the outlet is not controlled by a dimmer or switch. Check the battery.

Why does the word “bat” keep flashing on the display?

(You will also hear a “chirp” once a minute.) The battery is weak or miss- ing. Install a new battery immediately.

Why is the word “bat” continuously displayed?

The unit is operating on battery back-up.

Why isn’t the remote Test/Silence responding?

You may be standing too far away.

Your remote may not be compatible.

You may have accidentally disabled the feature.

You must hold the button on your remote for at least 2 seconds to acti- vate the Silence feature.

The remote Silence feature only works once in an alarm situation. Using the Test/Silence button on the CO Alarm will still silence the unit. The remote Silence feature will return when the unit clears itself.

Why does the Alarm sound three rapid “chirps” every minute?

Make sure the battery is installed correctly. If the display reads “Err,” replace the CO Alarm immediately. Units under warranty can be returned to the manufacturer for replacement. See Warranty for details.

Why does the alarm sound again about 4 minutes after I used the Silence Feature?

CO levels still indicate a potentially dangerous situation. Refer to “If Your CO Alarm Sounds” for details on how to respond to an alarm. If anyone is feeling ill, EVACUATE your home immediately.

Why does the CO Alarm sound frequently, but no high levels of CO are found in an investigation?

The CO Alarm may be improperly located. Try relocating your alarm. (Refer to “Where to Install CO Alarms.”) If frequent alarms continue, have home rechecked for potential CO problems. You may be experiencing an intermittent CO problem.

LIMITED WARRANTY

GENERAL LIMITATIONS OF CO ALARMS

This CO Alarm is intended for residential use. It is not intended for use in industrial applications where Occupational Safety and Health Administration (OSHA) requirements for carbon monoxide detectors must be met.

CO alarms may not waken all individuals. If children or others do not readily waken to the sound of the CO alarm, or if there are infants or family members with mobility limitations, make sure that someone is assigned to assist them in the event of an emergency.

CO Alarms will not work without power. This CO Alarm requires a continu- ous supply of AC power. Plug into an unswitched 120V AC outlet only. The battery back-up is for emergency use only!

CO Alarms for Solar or Wind Energy users and battery backup power systems: AC powered CO Alarms should only be operated with true or pure sine wave inverters. Operating this CO Alarm with most battery-powered UPS (uninterruptible power supply) products or square wave or “quasi sine wave” inverters will damage the Alarm. If you are not sure about your inverter or UPS type, please consult with the manufacturer to verify.

This CO Alarm will not sense carbon monoxide that does not reach the sensor. This CO Alarm will only sense CO at the sensor. CO may be present in other areas. Doors or other obstructions may affect the rate at which CO reaches the CO Alarm. For this reason, if bedroom doors are usually closed at night, we recommend you install a CO Alarm in each bedroom and in the hall- way between them.

CO Alarms may not sense CO on another level of the home. For example, a CO Alarm on the second level, near the bedrooms, may not sense CO in the basement. For this reason, one CO Alarm may not give adequate warning. Complete coverage is recommended. Place CO Alarms on each level of the home.

CO Alarms may not be heard. The alarm horn loudness meets or exceeds current UL standards of 85 dB at 10 feet (3 meters). However, if the CO Alarm is installed outside the bedroom, it may not wake up a sound sleeper or one who has recently used drugs or has been drinking alcoholic beverages. This is especially true if the door is closed or only partly open. Even persons who are awake may not hear the alarm horn if the sound is blocked by distance or closed doors. Noise from traffic, stereo, radio, television, air conditioner, or other appliances may also prevent alert persons from hearing the alarm horn. This CO Alarm is not intended for people who are hearing impaired.

CO Alarms are not a substitute for a smoke alarm. Although fire is a source of carbon monoxide, this CO Alarm does not sense smoke or fire. This CO Alarm senses CO that may be escaping unnoticed from malfunctioning furnaces, appliances, or other sources. Early warning of fire requires the installation of smoke alarms.

CO Alarms are not a substitute for life insurance. Though these CO Alarms warn against increasing CO levels, BRK Brands, Inc. does not warrant or imply in any way that they will protect lives from CO poisoning. Homeowners and renters must still insure their lives.

CO Alarms have a limited life. Although the CO Alarm and all of its parts have passed many stringent tests and are designed to be as reliable as possi- ble, any of these parts could fail at any time. Therefore, you must test your CO Alarm weekly.

CO Alarms are not foolproof. Like all other electronic devices, CO Alarms have limitations. They can only detect CO that reaches their sensors. They may not give early warning to rising CO levels if the CO is coming from a remote part of the home, away from the CO Alarm.

BRK Brands, Inc. ("BRK") the maker of First Alert® brand products, warrants that for a period of 5 years from the date of purchase, this product will be free from defects in material and workmanship. BRK, at its option, will repair or replace this product or any component of the product found to be defective during the warranty period. Replacement will be made with a new or remanufactured product or component. If the product is no longer available, replacement may be made with a similar product of equal or greater value This is your exclusive warranty.

This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance. BRK dealers, service centers, or retail stores selling BRK products do not have the right to alter, modify or any way change the terms and conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the following: negligent use or misuse of the product, use on improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration by anyone other than BRK or an authorized service center. Further, the warranty does not cover acts of God, such as fire, flood, hurricanes and tornadoes or any batteries that are included with this unit.

BRK shall not be liable for any incidental or consequential damages caused by the breach of any express or implied warranty. Except to the extent prohibited by

applicable law, any implied warranty of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. Some states, provinces, or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state, or province to province.

How to Obtain Warranty Service:

Service: If service is required, do not return the product to your retailer. In order to obtain warranty service, contact the Consumer Affairs Division at 1-800-323-9005, 7:30 AM to 5:00 PM, Central Standard Time, Monday through Friday. To assist in serving you, please have the model number and date of purchase available when calling.

303 Nelson Avenue, Neosho, MO 64850-8806.

Battery: BRK Brands, Inc. make no warranty, express or implied, written or oral, including that of merchantability or fitness for any particular purpose with respect to battery.

For your records, please record:

Date Purchased: ____________________________

Where Purchased: _______________________________________

First Alert® is a registered trademark of the First Alert Trust.

Printed in Mexico M08-0018-002 P 07/04

6

Image 6
Contents Introduction Table of ContentsHOW Your CO Alarm Works USER’S ManualWhere to Install CO Alarms InstallationUnderstanding Your CO Alarm Using the Remote Control TEST/SILENCE FeatureIf Your CO Alarm Sounds Testing and Maintenance What YOU Need to Know about CO Underwriters Laboratories INC. UL2034How to Obtain Warranty Service Limited Warranty General Limitations of CO AlarmsFrequently Asked Questions UL2034 Information

FCD4 specifications

The First Alert FCD4 is a highly regarded combination smoke and carbon monoxide detector, designed to enhance home safety through advanced technology and innovative features. This unit is particularly notable for its dual functionality, providing reliable detection for both smoke and carbon monoxide—two of the most significant threats to home safety.

One of the main features of the First Alert FCD4 is its photoelectric smoke detection technology. This system is designed to minimize false alarms often triggered by cooking smoke or shower steam, making it a suitable choice for kitchens and bathrooms. Photoelectric sensors detect larger smoke particles produced by smoldering fires, offering a fast response to potential hazards while reducing unnecessary disturbances.

The FCD4 is equipped with an electrochemical CO sensor, which is the most effective technology for detecting carbon monoxide. This feature allows the device to monitor CO levels continuously, providing alerts before harmful levels are reached. The combination of smoke and CO detection in one unit simplifies installation and maximizes safety by ensuring that homeowners are alerted to multiple dangers with a single device.

Another characteristic of the First Alert FCD4 is its battery operation, which enhances its reliability. The unit comes with a 10-year battery life, eliminating the need for frequent battery changes. Additionally, it features a convenient battery lockout system that helps prevent the device from being accidentally powered on without a battery in place, enhancing safety during installation.

A notable convenience feature of the FCD4 is its easy-to-read LED display that indicates the status of the unit, including whether it is in alarm mode or when the battery needs to be replaced. The device also includes an easy-access testing and silencing button, which allows homeowners to test its functionality quickly and silence alarms without removing the batteries.

The First Alert FCD4 meets safety standards set by Underwriters Laboratories, ensuring it has been rigorously tested for reliability and effectiveness. It stands out as a comprehensive safety solution, combining modern technology with user-friendly features and a commitment to protecting families from the dangers of smoke and carbon monoxide.