GE AHG30LH Removing Collected Water, Installing the Water Bucket, Water Level, Use a hose. Water

Usingthe dehumidifier.

Always make sure the water bucket is locked into place on the dehumidifier.

Removing Collected Water

There are 3 ways to remove collected water:

[]

Use the bucket "x, hen the bucket

is relnoved,

[] Use

a floor

drain.

The unit

can

also

be

placed

the unit will shut off. Empq and

replace the

oxer

a

floor

drain.

Using

a drill, make

a

hole

bucket.

at the

end

of the

nozzle located

on

the

lower

left side of the bucket,

				Drill
[] Use a hose. Water	can	be	automatically	\
emptied into a floor		drain	by attaching	a
water hose (not	included)		to the bucket	hose

nozzle. Using a drill, make a hole at the end of the nozzle located on the lower left side of

the bucket. Attach a water hose to the bucket nozzle. Fasten by hand only.

Drill hole:	Attach hose:
	Nozzle
	Hose

NOTE:Thenozzlecannot be fixed after puncture. Use an ordinary garden hose cap (not included) to reclose if necessary

NOTE:Avoidusing mechanical tools to tighten the water hose to the bucket nozzle.Thismay damagethe threads on the nozzle.

Installing the Water Bucket

Lift the bucket and hook the slots on each side

onto the posts on the back of the dehmnidifie_:

The bucket should lock secm'elx in place.

Make sm'e the bucket is locked securely in place by pressing down on the ui)per back edge of the

bucket. It will be firefly seated when l)roperly installed.

Post

Water Level

The dehumidifier will turn off automatically

when the bucket is flfl], or when the bucket is

removed or not replaced in the proper position.

The bucket must be replaced in the proper position for

the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the

proper position.