Kenmore 580.53650 owner manual Are position correcty

When the bucket is full, or when l_e bucket is not in the proper position, the Bucket Fult light turns on and the u_it automaticaty shuts ofi_

A_so, when bucket is out of position, the unit wtl beep 3 times.

The bucket must be replaced in the proper posilon for the dehumidifier to work, The fight will be on and the dehumidifier wil net run if the bucket is not in the proper position,

The water" bucket can be emptied Empty the bucket manualy. When the bucket is full,

remove and empty it into a Iarge sink or tub. Whe_ finished, replace it properly. NOTE: To replace the bucket property, make sure the slots on the back of bucket

are position_ correcty,

in one of three ways: Place the dehumidifier directly over drain.

The bucket has a threaded hose connection which can be left open. Drill a U4" (6.4ram) to !/2"(13mm) hole in the center of the hose connection. Once opened, the hose connection wll continualy drain water from the bucket.

Attach a garden hose to the threaded bucket drain hose

connection to carry water to the drain, (HANDTIGHTENONLY}

When being attached to the bucket drain hose connection, be sure the hose doesn't kink or bend. It should lie flat from the dehumidifiet" to the drain.