NAMES OF PARTS
Control Panel
Air Inlet
Water tank
Castors
CONTROL PANEL
Air Outlet
Wiring Ear
Drain Hole
(For permanent drainage)
Power Cord
1ON/OFF Button: When the unit is connected to the power(initial power), the POWER indicator will flash slowly. Press the ON/OFF button at this time, the unit will directly go into
DEHUMIDIFYING operation with the original factory humidity setting( 60%RH). Press the ON/OFF button again, the unit will stop operation.
2
Button: When the unit is in operation, press the 
Button will go into CONTINUOUS DEHUMIDIFYING mode.
3FAN Button: By pressing the FAN button, the fan speed will change in sequence below: HIGH
4POWER indicator: At the first time to connect to the power, it flashes slowly The POWER indicator lights when the unit is turned on, and dark when the unit is turned off.
5
indicator: Lights when the unit is on CONTINUOUS DEHUMIDIFYING mode. 6 WATER FULL indicator: Lights when the bucket is full, and the unit stops operating.
7 HUMIDITY
Button: When the unit is in operation, the setting humidity will go up by pressing this button every time, the range of adjustment is from 35%RH to 80% RH.
8HUMIDITY
Button: When the unit is in operation, the setting humidity will come down by pressing this button every time, the range of adjustment is from 80%RH to 35%RH.
9HIGH FAN indicator: Lights up when HIGH FAN speed is selected.
10LOW FAN indicator: Lights up when LOW FAN speed is selected.
2