Danby DDR45E, DDR30E Start Operation, Water Full Indicator Light RED, Bucket Full Light, Factory

Page 6

OPERATING INSTRUCTIONS (cont’d)

START OPERATION

1)Place the product in an upright position on a flat, stable, and heat- resistant surface. Make sure there is nothing flammable or heat sensitive within 100cm (39 inches). Operating the product in any other position could cause a hazard.

2)Insert the plug into a suitable wall socket. The dehumidifier is suitable for operating on an electricity supply having the same voltage as that

shown on its rating label.

3)Make sure the water tank is correctly located. After switching on the machine for the first time, if the “Bucket Full” light illuminates, pull out the water tank and check that the “float” lever is able to move freely, then return the water tank to the correct position (Fig. 1).

Fig. 1

WATER FULL

INDICATOR LIGHT (RED)

When the water tank is full and/or incorrectly positioned inside the cabinet, the water full red light turns on and remains on until such time that the tank is emptied and/or correctly re-positioned.

This condition will result in the immediate shut down of the dehumidifying system (both compressor and fan motor operations are terminated). This is a safety feature. When the water tank is emptied and/or correctly re-positioned, the dehumidifier will resume operation automatically.

NOTE: It may take several minutes before operating conditions resume.

BUCKET

FULL LIGHT

•When the water tank is full the machine will stop and the“Bucket Full” light will illuminate.

•The water tank should be carefully removed from the machine by sliding it outward from the front of the unit, and it should be emptied. When the empty tank is replaced properly in the machine, the unit will start up and run normally (Fig. 2).

NOTE: Please use both hands to carefully empty the water tank.

Fig. 2

FACTORY

Each time the unit is disconnected/re-connected and/or in the event of a power failure,

DEFAULT SETTING

the electronic circuitboard automatically defaults to the following factory setting:

Humidity Setting: 60%

Fan Speed: Low

NOTE: In the event of a power failure, all previous settings are automatically erased/cancelled. If your

program setting was different from the above (default setting) it will be necessary to re-program your settings.When the unit is switched “Off” manually (using the on/off keypad) the unit will always default to the last program setting that was used.

WATER TANK

Proper installation of the water tank is crucial in maintaining reliable dehumidifier

OPERATION

operation. The water tank holds accumulated condensed water and, by means of a safety

 

switch, controls both the water level and operation of the dehumidification process.

 

When the water tank is full and/or accidentally displaced inside the cabinet, the float switch actuator (inside the tank) breaks contact with the safety switch. This condition results in the immediate shut down of the compressor and fan motor system, preventing moisture from being condensed.

NOTE: Never tamper with or attempt to defeat the water level (safety) float switch system.

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents DDR25E, DDR35E, DDR45E 800-26 WelcomeModel Number Serial Number Date of Purchase Keep These Instructions for Future ReferenceImportant Safety Information GroundingInstructions Installation Instructions Castor InstallationLocation Features Power Button On / Off FAN Speed Button High / LowOperating Instructions Start Operation Water Full Indicator Light REDDefault Setting Bucket Full LightDefrost Dehumidifying Mode SelectionAIR Filter Cleaning Steps DehumidifyingInstalling PVC Drain Hose ContinuousDrain Page Care and Maintenance TroubleshootingProblem Possible Cause Bienvenue Numéro de modèle Numéro de série Date d’achatRemarque Consignes DE Sécurité ImportantesSauvegarde CES Instructions ConditionsInstructions D’INSTALLATION ’EMPLACEMENTInstallation DE LES Roulettes Caractéristiques Consignes D’OPÉRATIONLumière DE EAU Plein Commencez L’OPÉRATIONLE Voyant Lumineux DE Réservoir Plein Rouge RéglageDécongeler Filtre À AIRDéposer DU Filtre À AIR Installation DE Drainage EN PVC DrainageContinu Précautions Probleme Cause Probable Soins ET EntretienDépannage DDR25E, DDR35E, DDR45E Product Type Model Number Part Number Part Description

DDR30E, DDR45E, DDR25E specifications

The Danby DDR series of dehumidifiers, specifically the DDR30E, DDR25E, and DDR45E models, are designed to efficiently manage humidity levels in both residential and commercial spaces. These units are equipped with advanced features and technologies aimed at enhancing performance, ease of use, and energy efficiency.

Starting with the Danby DDR30E, this model is ideal for small to medium-sized areas, effectively removing up to 30 pints of moisture per day. It's perfect for bedrooms, basements, or laundry rooms, helping to prevent mold and mildew growth. The DDR30E features a user-friendly control panel with an adjustable humidistat, allowing users to set their desired humidity level. Additionally, the continuous drain option provides convenience for longer periods of use without the need for manual emptying.

Next, the Danby DDR25E model offers similar capabilities, albeit slightly smaller in capacity, removing up to 25 pints of moisture daily. It is engineered for efficiency and portability, featuring lightweight design and easy-roll casters, making it simple to move from one room to another. The DDR25E also boasts an internal pump for drainage, which allows for higher placement of the unit without worrying about gravity draining.

The DDR45E stands out with its increased capacity, effectively removing up to 45 pints of moisture per day, making it suitable for larger spaces or areas with persistent dampness. This model incorporates a smart dehumidifying technology that automatically adjusts the fan speed to optimal levels based on room conditions, ensuring energy conservation without compromising performance. The washable air filter is another significant feature, allowing for easy maintenance and extended lifespan of the unit.

All three models utilize a refrigerant system that is both environmentally friendly and effective in dehumidifying, ensuring that users can maintain comfortable and healthy indoor air quality. These units also come equipped with an energy-star certification, ensuring that they operate efficiently, which helps reduce electricity costs.

In summary, the Danby DDR30E, DDR25E, and DDR45E dehumidifiers offer a range of capacities and features suitable for different needs. With their focus on user-friendliness, energy efficiency, and robust moisture removal capabilities, each unit stands as a reliable solution for maintaining optimal humidity levels in any property.
Top Page Image Contents