Danby DDR25E, DDR45E, DDR30E installation instructions Installing PVC Drain Hose, Continuous

OPERATING INSTRUCTIONS (cont’d)

INSTALLING PVC

DRAIN HOSE

When using the continuous drain function, the PVC hose must be placed horizontally below the drainage hole. Avoid uneven ground and folding the hose.

NOTE: Should you damage or misplace the pvc drain hose, a standard garden hose can be used.

CONTINUOUS

DRAIN	The function of continuous drain can be performed using the following steps:
1) To save having to periodically empty the water tank, this unit can			Back of the unit
				Fig. A
		Drain hose
be configured for continuous drain. You can use the supplied
drain hose to connect to the continuous drain connector.

2)Unscrew and remove the drain cover at the rear of the unit (Fig. A).

3)	Remove the soft rubber stopper, and place it in the water tank for					Drain cover
	safe keeping (Fig. B).
							Fig. B
4)	Insert the drain hose through the hole of the drain cover (Fig. C).		Soft		rubber
5)	Ensure the rubber seal ring is properly seated in the end of the		stopper
				Drain cover
	hose as shown in Fig. C.
6)
	Connect the drain hose to the drain port (Fig. D).
								Fig. C
7) Tighten the drain cover in clockwise direction onto the rear of		Drain cover
	the unit (Fig. D).
		Drain hose

8)Place the bucket in its original location (Fig. E).

Fig. D

Drain cover

Drain hose

	Fig. E
Drain hose

Bucket

7