KitchenAid KBEU121T Installation Requirements, ToolsandParts, ProductDimensions

Page 5

INSTALLATION REQUIREMENTS

ToolsandParts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

ProductDimensions

A

Tools Needed

Tape measure

Small, flat-blade screwdriver

Flat-blade screwdriver

#2 and #3 Phillips screwdriver

Level

Wrench or pliers

Pipe wrench

Noncorrosive leak detection solution

Parts Needed

Gas line shutoff valve

½" male pipe thread nipple for connection to pressure regulator

LP gas-resistant pipe-joint compound

CSA design-certified outdoor flexible stainless steel appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as needed.

Parts Supplied

Convertible regulator set for 4" WCP Natural gas.

Single-prong plug/transformer assembly

LocationRequirements

Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas.

Do not obstruct flow of combustion and ventilation air.

Clearance to combustible construction for built-in sear burner:

A minimum of 24" (58 cm) must be maintained between the sides and back and any combustible construction.

A 24" (58 cm) minimum clearance must also be maintained below the cooking surface and any combustible construction.

Ignition

A grounded, 3 prong outlet located to the left of the sear burner is required. See “Electrical Requirements” section.

B

C

D

E

F

G

 

 

 

 

 

 

 

 

 

 

 

H

 

 

 

 

 

 

 

A. 13"

(33 cm)

 

E. 25³⁄₈" (64.5 cm)

B. 12³⁄₄" (32.4 cm)

 

F. Manifold pipe

C. 17"

(43.2 cm)

 

G. 2¹⁄₂" (6.4 cm)

D. 26³⁄₈" (67 cm)

 

H. 22³⁄₄" (57.8 cm)

Built-In Outdoor Sear Burner Enclosure

The enclosure for the built-in outdoor sear burner is to be a minimum of 11" (28.0 cm) high x 23" (58.4 cm) deep x 14" (35.6 cm) wide.

CabinetDimensions

Enclosure and clearance dimensions that are shown must be used. Given dimensions provide required clearances.

Counter or support surfaces must be level.

The installation of this sear burner must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.

Copies of the standards listed may be obtained from: CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

NOTE: The outdoor sear burner drops into the enclosure opening and is supported by its side flanges. No bottom support is needed.

5

Image 5
Contents Outdoor BUILT-IN Sear Burner Table DES Matières Your safety and the safety of others are very important Outdoor BUILT-IN Sear Burner SafetyImportant Safety Instructions ProductDimensions Installation RequirementsCabinetDimensions ToolsandPartsRecommended Ground Method ElectricalRequirementsGasSupplyRequirements OutdoorSearBurnerInstallation Installation InstructionsMake Gas Connection Natural Gas Use Plug in Sear BurnerLighting theInfraredSear Burner CheckandAdjusttheBurnersOutdoor Sear Burner USE GeneralCleaning UsingYourInfraredSearBurnerOutdoor Sear Burner Care Manually Lighting Infrared Sear BurnersStainless Steel Cleaning MethodAssistance or Service TroubleshootingAccessories IntheU.S.ACall Kitchenaid Outdoor Product WarrantyVotre sécurité et celle des autres est très importante Sécurité DU Brûleur À Infrarouge Encastré DextérieurConservez CES Instructions Dimensionsduproduit Exigences DinstallationExigencesdemplacement DimensionsduplacardSpécificationsélectriques Méthode recommandée de mise à la terrePuissance thermique des brûleurs en altitude SpécificationsdelalimentationengazTest de pressurisation de la canalisation de gaz Gaz naturelRaccordement au gaz Alimentation au gaz naturel Instructions DinstallationInstallation dubrûleurà infrarouge Dextérieurencastré Allumagedu brûleuràinfrarouge Utilisation DU Brûleur InfrarougeContrôleetréglagedesbrûleurs Utilisationdubrûleuràinfrarouge Entretien DU BrûleursNettoyagegénéral Bouteille de propane de 20 lb après conversionMéthode de nettoyage Acier InoxydableAccessoires Assistance OU ServiceDépannage Garantie DES Produits Pour Usage Extérieur KitchenaidW10117506 Kitchenaid NE Prendra PAS EN Charge

KBEU121T specifications

The KitchenAid KBEU121T is a high-performance kitchen appliance designed for the modern home chef. Combining cutting-edge technologies with a sleek design, this blender is perfect for blending, pureeing, and making a variety of recipes, from smoothies to soups. One of the standout features of the KBEU121T is its powerful motor, which delivers exceptional blending performance, tackling even the toughest ingredients with ease.

The blender boasts a 1200-watt motor that can reach high speeds, enabling users to achieve smooth and consistent results in a matter of seconds. The variable speed control allows users to adjust the blending speed according to the recipe, ensuring optimal texture and consistency. A pulse function is also included, providing an extra burst of power when needed, making it ideal for chunky salsas and finely chopping ingredients.

Equipped with a unique asymmetric blade design, the KBEU121T ensures that all ingredients are evenly blended, preventing unwanted chunks in your mixture. The stainless steel blades are durable and efficient, designed to withstand daily use and maintain their sharpness over time. The large, 1.5-liter blending jar is made from BPA-free materials and features a pour spout for effortless serving.

The KBEU121T also emphasizes ease of use with its intuitive interface and one-touch controls. The ergonomic design of the blender makes it comfortable to handle, while the non-slip base provides stability during operation. Cleaning is a breeze, as the blending jar and blades are dishwasher safe, allowing for quick and easy maintenance.

Another impressive feature of the KitchenAid KBEU121T is its built-in technology. The blender includes intelligent programs that automatically adjust blending times and speeds based on the load in the jar, ensuring perfect results every time.

For those who value aesthetics in their kitchen appliances, the KBEU121T is available in an array of stylish colors to suit any kitchen decor. The high-quality finish and modern design not only deliver exceptional performance but also enhance the kitchen’s visual appeal.

In summary, the KitchenAid KBEU121T is an all-around powerful and user-friendly blender that simplifies food preparation while enhancing the cooking experience. With its robust features, modern technology, and elegant design, it is an essential addition to any culinary enthusiast's kitchen.