Kenmore 5EW1.75, 4EW.90, 3EW.75, 3E W.65, 5EW2.00, 5EWL.20, 4EW1.50 Typical Chimney Connection

Page 17

TYPICAL CHIMNEY CONNECTION

MUST BE AT LEAST 4 INCHES THICK-

AND BE TIGHT.

MUST SLOPE UP

AT LEAST 1/4 INCH PER FOOT OF

HORIZONTAL RUN

DRAWBAND

LAST PIECE

INSTALLED

TIGHT, SMOOTH, CORRECTLY SIZED.

I

I

!

SEALED IN THIMBLE

.TIGHT

CLEAN-OUT

DOOR

MUST BE REQUIRED MIN-

IMUM HEIGHT• MUST RE

AT LEAST 3 FT. HIGHER

THAN HIGHEST PART QF

PASSAGE THROUGH

ROOF. MUST BE AT

LEAST 2 FT. HIGHER

THAN ANY NEIGHBORING

OBJECT. MUST HAVE AN

UNOBSTRUCTED TOP

OPENING.

DRAFT REGULAT(

VANE

CRIMPEDENO

BALANCED WEIGHT

ALTERNATE POSITIONS

. TOP

15

Image 17 Contents
Off-Fired Hot Water Boiler Kennmore Cast Iron Boilers TIEml IntroductionCapacities RatingsRules for Safe Installation and Opeiltion Locating the Boiler Installation Requirelments Inote Fresh AIR for CombustionDuct Size Twothrottlingvalves to System PipingSupply to System System Piping Arrangement Zoning with Zone ValvesSystem Piping Arrangement Zoning with Circulators System Piping Arrangement Alternate Near Boiler Piping Burner Firing Number Recommended Minimum Chimney Sizes Chimney and Chimney ConnectionsTypical Chimney Connection Thermostat Electrical ConnectionsSE/ARS Automatic Fill Valve not provided HOW a HOT Water System Operates Filling the BoilerBeckett OIL BURNER, NOZZLE, and AIR Settings Final Burner Adjustments GAP 32 4 mm 64 to 7/64 or 2 to 2.5 m 32 or 4 mm Checking and Adjusting Controls Maintenance OIL Boiler / Burner Cleaning Instructions OIL Burner Cleaning To do Electrical WiringSoP.LY Service Company Serviceman Address Telephone Operation SequenceSequence of Operation Boiler Less Tankless Coil Parts RepairPa # Balloon 5YMBOL KEY Description Repair PartsBeckett OIL Burner NOZZLE, and AIR Settings Oi/-Fired Hot Water Boiler