JVC CA-MXJ900 manual Troubleshooting, Symptom

Page 30

English

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

No sound is heard.

Hard to listen to broadcasts because of noise.

The disc sound is discontinuous.

The disc tray does not open or close.

The disc does not play.

The cassette holders cannot be opened.

Impossible to record.

Stereo effect is lost.

Operations are disabled.

Unable to operate the unit from the remote control.

Cause

Connections are incorrect or loose.

Antennas are disconnected.

The AM loop antenna is too close to the unit.

The FM antenna is not properly extended and positioned.

The disc is scratched or dirty.

The AC power cord is not plugged in.

Trays are locked.

The disc is placed upside down.

Power supply from the AC power cord has been cut off while the tape was running.

Small tabs on the back of the cassette are removed.

Vocal Masking is activated.

The built-in microprocessor may malfunction due to external electrical interference.

The path between the remote control and the remote sensor on the unit is blocked.

The batteries are exhausted.

Action

Check all connections and make corrections. (See pages 6 to 8.)

Reconnect the antennas correctly and securely.

Change the position and direction of the AM loop antenna.

Extend the FM antenna at the best position.

Clean or replace the disc. (See page 24.)

Plug the AC power cord.

Unlock the trays. (See page 15.)

Place the disc with the label side up.

Turn on the unit.

Cover the holes with adhesive tape.

Cancel the Vocal Masking. (See page 20.)

Unplug the AC power cord and then plug it back in.

Remove the obstruction.

Replace the batteries.

– 25 –

Image 30
Contents CA-MXJ900 Precaución -- Interruptor Precaución CA-MXJ900 Class Laser Product Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Powered Rolling Panel Display WindowRemote Control Remote ControlConnecting Antennas Getting StartedUnpacking To connect an outdoor AM antenna Connecting SpeakersAM antenna For better reception of both FM and AMRelease the finger from the clamp Connecting Other EquipmentAdjusting the Voltage Selector Press and hold Demo for more than 2 secondsSetting the AM Tuner Interval Spacing Turning On and Off the PowerSetting the Clock Common OperationsReinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesSurround modes Creating Your Own Sound Mode Manual ModeTo use your own sound mode SEA Sound Effect Amplifier modesTuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM BroadcastsPlaying Back the Entire Discs Continuous Play Playing Back CDsLoading CDs Basic CD OperationsPress CD £·8 Program PlayProgram other tracks you want To locate a particular point in a trackRepeating Tracks or CDs Repeat Play To check the program contentsPlaying at Random Random Play Prohibiting Disc Ejection Tray LockPlaying Back Tapes Playing Back a TapeLocating the Beginning of a Song Music Scan To record on both sides Reverse Mode RecordingRecording a Tape on Deck B To record an AM station Beat Cut Dubbing TapesPress Dubbing To stop during dubbing, pressPress Edit Auto Edit RecordingOn the unit only Load CDs Press SETUsing the Microphones Singing AlongUsing the Timers Using Daily TimerWhen selecting Tuner FM or Tuner AM Using Recording TimerWhen selecting CD Press 4or ¢to set the volume levelUsing Sleep Timer Timer PriorityHandling discs MaintenanceTo clean the disc Handling cassette tapesTroubleshooting SymptomSpecifications JVC 0200MWMMDWJEM
Related manuals
Manual 28 pages 40.03 Kb