Nady Systems EO3RXFF, EO3RXEE, EO3RXBB, EO3BB, EO3RXDD, EO3HH, EO3EE Introduction, Important Note

Page 3

Introduction

Thank you for choosing the Nady EO3 Personal In Ear Monitorwireless system, we know you will be very pleased with its performance and features. The EO3 provides high quality, yet cost-effective in-ear monitoring to on stage performers or behind the scenes personnel. The system is designed to be very easy to use and requires no installation.

The EO3 consists of one wireless transmitter (EO3-T) and one or more wireless bodypack receivers (EO3-R) on the same channel. The transmitter features eight factory switchable channels; the receivers are single channel units that operate on one of eight channels in the 72-76 MHz band, with wide band modulation for quality audio. These frequencies are in a separate band that will not interfere with simultaneous use of VHF or UHF wireless systems on the same stage.

The EO3 system has a wireless operating range of 300 feet, which allows it to be used with confidence in venues from small clubs to large theatres.

The transmitter connects to a monitor or line out from any mixing console, and broadcasts the audio as an FM signal to any number of pocket size Nady EO3 receivers on the same channel. Each receiver is equipped with an adjustable volume control, and high performance earbuds.

Earphone enhancers—unique clear soft plastic inserts that can help secure the earbuds—are included. The transmitter also provides a microphone input to allow wireless cueing of the performers on stage.

The EO3 can provide a high quality monitor mix at significantly lower decibel levels than floor monitors. This is an important benefit for artists who wish to protect their hearing from excessive and potentially damaging sound pressure levels.

Please read this manual completely before using your Nady EO3.

Important Note

Just as with any in-ear monitor system, the EO3 works best when used exclusively by all the performers on stage—without any wedges or side monitors. The high sound pressure levels produced by floor monitors (especially if the band plays loud) can bleed through the in-ear monitor earbuds, in the worst cases, thus hindering their effectiveness. Experiment with your mix to get the maximum benefit from your EO3.

3

Image 3
Contents EO3 Contents Important Note IntroductionEO3 Transmitter EO3 Transmitter Front Panel EO3 Transmitter Rear Panel Confirming Correct InstallationUsing More Than One EO3 System Channel SelectionOperating the Receiver Powering The ReceiverUsing the Earbuds EO3 ReceiverAdjusting Ear Monitor Volume Testing Receiver RangeEO3 Receiver Front Panel Total Harmonic Distortion RF Carrier Frequencies EO3 SpecificationsService Information This warranty is subject to the following conditions One-Year Limited Warranty