Confirming Correct Installation
The transmitter’s TX LED (6) will flash when a microphone or line level signal is broadcast by the transmitter. If “TX” does not flash, turn the audio input gain control clockwise. This will increase audio level and cause “TX” to flash along with the program source. When “TX” is flashing, the transmitter is broadcasting properly. Test the transmitter with an EO3 receiver. This procedure is explained in the receiver instructions.
Note: For the best performance, and to minimize the possibility of interference from another source, we suggest you experiment to find the minimal height the antenna must be extended in order to perform well in your particular environment.
Channel Selection
Channel selection is controlled by DIP‑switches inside the transmitter. The system is preset at the factory.
Changing the channel can be done quickly by any qualified service technician. Contact your dealer or the Nady Customer Service Department for details.
Using More Than One EO3 System
You may operate up to three EO3 systems in the same location. For example, you may want to use one transmitter to provide a mix to the rhythm section, a second to provide a different mix for the vocalist. For multiple system operation, please observe:
•If operating two EO3 transmitters in the same location, use Ch. AA and HH (or GG)
•If operating three EO3 transmitters in the same location, use Ch. AA, EE and HH (or GG)
•Locate the transmitters ten feet or more away from the performers wearing EO3 receivers
EO3 Transmitter (Front Panel)
7 | 6 | 2 | 3 |
EO3 Transmitter (Rear Panel)
4
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
5 | 8 | Channel switches (inside) | 1 | |||||
|
|
|
|
|
| |||
5