Firex FADCQ manual Typical Efficiency Home Apartment, Typical Mobile Home

Page 29

The NFPA, 1993 Edition, Appendix A further states:

“The required number of smoke detectors may not provide reliable early warning protection for those areas separated by a door from the areas protected by the required smoke detectors.

BEDROOM HALL BEDROOM

LIVING

DINING

ROOM

ROOM

/

BASEMENT

Typical Efficiency Home (Apartment)

Install a combination alarm on the ceiling or wall closest to the sleeping area.

DINING

ROOMKITCHEN BEDROOM

TV ROOM

LIVING ROOM

BEDROOM

BEDROOM

Typical Mobile Home

NOTE: For mobile homes built before 1978, install alarms on an inside wall between 4 and 12 inches from the ceiling. (Older mobile homes have little or no insulation in the ceiling.) This is

For this reason, it is recommended that the house holder consider the use of additional smoke detectors for those areas for increased protection. The additional areas include: base- ment, bedrooms, dining room, furnace room, utility room, and hallways not protected by the required smoke detectors.”

Also, as required by the

California State Fire Marshal:

“Early warning fire detection is best achieved by the installation of fire detection equipment in all rooms and areas of the household as follows: a smoke detector installed in each separate sleep- ing area (in the vicinity, but outside the bed- rooms), and heat or smoke detectors in the liv- ing rooms, dining rooms, bedrooms, kitchens, hallways, attics, furnace rooms, closets, utility and storage rooms, basements and attached garages.”

For best protection, install a smoke alarm in EVERY room. In addition, we recommend that all smoke alarms be interconnected.

especially important if the ceiling is unusually hot or cold.

Install a combination alarm inside each bedroom and in the hallway outside each separate sleeping area.

29

Image 29
Contents Please Read and Save this Manual SMOKE/CARBON Monoxide Alarm Model FadcqPage Table of Contents About this Alarm General Information and FeaturesFeatures/Benefits Quick Quiet False Alarm Control Quick Reference GuidesPage Important Safety Information Carbon Monoxide CO is a Toxic Gas Different Types of Smoke AlarmsFire is Unpredictable Check Your Local Building Codes Where to Install This AlarmPlacement Guidelines Installation for Battery DC Operation Only II. HOW to Install this SMOKE/CO AlarmInterconnecting TWO Battery DC only Alarms Activate the batteryInstallation For AC With Battery Back-up Interconnecting Two Battery DC Only AlarmsNation and or Smoke Alarms Secure plate to junction box using mounting screwsTo Install Combination Unit as a Replacement If Your Smoke Alarm Sounds III. if the Alarm SoundsIf Your CO Alarm Sounds What to Do in Case of a FirePotential Sources of CO Your Home Quick Quiet False Alarm Control and Smart QuietIf Your CO Alarm Sounds cont’d Smart Quiet Latching LED Alarm IndicatorSmart Quiet for LOW Battery Alert RED-YELLOW-ORANGE and Blue IV Understanding the Indicator LightsCondition Horn Understanding the Alarm LEDs and Horn PatternsLEDs Smart Button KEYTesting Testing and MaintenanceTest all combination alarms weekly by doing the following To test an individual smoke and CO alarm local testBattery Replacement Maintenance and CareTo Replace the Battery CleaningRepair Climate Controls AmericasProblem Solution VI. Troubleshooting the SMOKE/CO AlarmWhere to Install this Alarm Troubleshooting the Smoke/CO AlarmCO Home Safety Tips VII Important Safety InformationFire Safety Tips Symptoms of Carbon Monoxide Poisoning Conditions That Can Cause CO Levels to Change Limitations of This Smoke/CO AlarmCoverage Important Information About This Smoke/CO AlarmProper Use/Operation Compliance/Proper ApplicationsAlso reads as follows Viii Agency Recommendations for Alarm PlacementAlso, as required by California State Fire Marshal Typical Efficiency Home ApartmentTypical Mobile Home Important Smoke Alarm Placement and Exception Information About Locating CO Alarms Year Limited Combination Smoke and CO Alarm Warranty IX Warranty Information