HOW to Install this SMOKE/CO Alarm

This Smoke/CO Alarm is designed to be mounted on any standard wiring junction box up to a 4-inch (10 cm) size, on either the ceiling or wall (if allowed by local codes). Read “Where to Install This Alarm” and “Where This Alarm Should Not Be Installed” before you begin installation.

Tools you will need: • Needle-nose pliers or utility knife • Standard flathead screwdriver • Wire strippers.

Make sure the Alarm is not receiving excessively noisy power. Examples of noisy power could be major appliances on the same circuit, power from a generator or solar power, light dimmer on the same circuit or mounted near fluorescent lighting. Excessively noisy power may cause damage to your Alarm.

THE PARTS OF THIS ALARM

The Mounting Bracket:

To remove the mounting bracket from the Alarm base, hold the Alarm base firmly and twist the mounting bracket counterclockwise. The mounting bracket installs onto the junction box. It has a variety of screw slots to fit most boxes.

The Power Connector:

The power connector plugs into a power input block on the Alarm. It supplies the unit with AC power.

•The black wire is “hot.”

•The white wire is neutral.

•The orange wire is used for interconnect.

If you need to remove the power connector, turn POWER OFF first. Insert a flat screwdriver blade between the power connector and the security tab inside the power input block. Gently pry back the tab and pull the connector free.

		The Parts of This Unit
		1	Mounting Bracket
		2	Mounting Slots
		3	Locking Pins (break out of
	6		bracket)
	6
		4	Hot (Black) AC Wire
	5	5	Neutral (White) AC Wire
4		5	Neutral (White) AC Wire
4	9	6	Interconnect (Orange) Wire
	9

10		7	Quick-Connect Power
		7	Quick-Connect Power
			Connector
		8	Turn this way to remove
			from bracket
	8	9	Turn this way to attach to
		9	Turn this way to attach to

bracket

710 Slide-Out Battery Drawer