S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M
3.Make the connections to the SVL-6. The amplifier/speaker connectors on the SVL-6 are removable. If you wish, you may remove the SVL-6's connectors to facilitate installation [see (Figure 3)]. Strip 3/8" of insulation from the end of each wire. Tightly twist the end of each wire until there are no frayed ends. Insert each wire into the appropriate hole on the connector terminals. Be certain that proper phasing is observed — connect the positive terminals on the SVL-6 to the positive terminals on the amplifier and speakers and the negative terminals on the SVL-6 to the negative terminals on the amplifier and speakers. Re-install the connectors if they were removed. See (Figure 4).
4.Locate the pre-printed Room Labels. Affix the appropriate label to the recessed area over each ON/OFF selector button.
Figure 3
Removing the Connectors
Figure 4
Installing the Connectors
