14 en Set up FMS | Fire Monitoring System |
|
|
Configuration
After installation, perform the following steps to configure your software:
1.
2.Enter Administrator as the user name and password.
3.Click the OK button. The FMS Manager opens, allowing you to configure the system.
4.Click the button Execute - FMS Configuration Wizard in the System start/stop tab. The configuration program opens.
5.Click the Next button. A
6.Enter Administrator as the user name and password.
7.Click the OK button. The configuration program continues.
8.Insert the disk supplied.
9.Step 1/6: Select the dongle.crp file from the disk.
10.Click the Next button.
11.Step 2/6: Note the determined server name.
12.Click the Next button.
13.Step 3/6: Specify a COM port (maximum of four) for each panel in the
14.Click the Next button.
15.Step 4/6: Click the button and select the corresponding detector check plan .mpp for each COM port.
16.Click the Next button.
17.Step 5/6: Click the button and enter the path of the folder containing the floor plans.
18.Click the Next button.
19.Step 6/6: Create all operators and their roles.
20.Then click the Create button.
21.Click the Close button to complete the configuration.
NOTICE!
i Click the Help button of the FMS Manager for additional information on configuration.
F.01U.032.785 A3 2007.05 | Installation Guide | Bosch Security Systems |